SB82371 Intel Corporation, SB82371 Datasheet - Page 42

• Manufacturer Part Number: SB82371
• Description: 82371FB (PIIX) AND 82371SB (PIIX3) PCI ISA IDE XCELERATOR
• Manufacturer: Intel Corporation

82371FB (PIIX) AND 82371SB (PIIX3)
2.2.17.
Address Offset:
Default Value:
Attribute:
This register enables/disables the Delayed Transaction and Passive Release functions, respectively. When
enabled, these functions make the PIIX3 PCI revision 2.1 compliant. Note that neither delayed completion nor
passive release have any effect on bus master IDE and type F DMA transfers.
The 2.1 revision of the PCI specification requires much tighter controls on target and master latency. Targets
must respond with TRDY# or STOP# within 16 clocks of FRAME#, and masters must assert IRDY# within 8
PCI clocks for any data phase. PCI cycles to or from ISA typically take longer than this. The PIIX3 provides a
programmable delayed completion mechanism described in the PCI specification to meet the required
target latencies.
ISA bridges also support GAT mode, which will now violate the spirit of the PCI specification. The PIIX3
provides a programmable passive release mechanism to meet the required master latencies. When passive
release is enabled in the PIIX3, ISA masters may see long delays in accesses to any PCI memory, including
the main DRAM array. The ISA GAT mode is not supported with passive release enabled. ISA masters must
honor IOCHRDY.
42
7:4
3
2
1
0
Bit
DLC—DETERMINISTIC LATENCY CONTROL REGISTER (Function 0) (PIIX3 Only)
Reserved.
SERR# Generation Due To Delayed Transaction Timeout Enable. 1=Enable. 0=Disable.
Passive Release Enable. 1=Enable the Passive Release mechanism encoded on the
PHOLD# signal (default). 0=PHOLD# functions identically to the way it did in the PIIX
(82371FB).
Delayed Transaction Enable. 1=Enable the Delayed Transaction mechanism when the
PIIX3 is the target of a PCI transaction (default). 0=PIIX3 resonds as a target of a PCI
transaction identically to the way the PIIX (82371FB) responded.
USB Passive Release Enable (USBPR). 1=Enable
82h
00h
Read/Write
Description
0=Disable.