APMOTOR56F8000E Freescale Semiconductor, APMOTOR56F8000E Datasheet - Page 122

• Manufacturer Part Number: APMOTOR56F8000E
• Description: KIT DEMO MOTOR CTRL SYSTEM
• Manufacturer: Freescale Semiconductor
• Type: Motor / Motion Controllers & Driversr

Specifications of APMOTOR56F8000E

• Accessory Type: Motor Controller
• Input Voltage: 9 V
• Interface Type: RS-232
• Product: Power Management Modules
• For Use With/related Products: DEMO56F8013, DEMO56F8013-E
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

122
•
•
•
•
•
•
PCB trace lengths should be minimal for high-frequency signals
Consider all device loads as well as parasitic capacitance due to PCB traces when calculating capacitance.
This is especially critical in systems with higher capacitive loads that could create higher transient currents
in the V
Take special care to minimize noise levels on the V
Using separate power planes for V
recommended. Connect the separate analog and digital power and ground planes as close as possible to
power supply outputs. If both analog circuit and digital circuit are powered by the same power supply, it is
advisable to connect a small inductor or ferrite bead in serial with both V
It is highly desirable to physically separate analog components from noisy digital components by ground
planes. Do not place an analog trace in parallel with digital traces. It is also desirable to place an analog
ground trace around an analog signal trace to isolate it from digital traces.
Because the Flash memory is programmed through the JTAG/EOnCE port, SPI, SCI or I
should provide an interface to this port if in-circuit Flash programming is desired.
DD
and V
SS
circuits.
56F8014 Technical Data, Rev. 11
DD
and V
DDA
and separate ground planes for V
REF
, V
DDA
and V
SSA
DDA
pins
and V
SS
Freescale Semiconductor
SSA
and V
traces.
2
C, the designer
SSA
is