PG-FP4-E Renesas Electronics America, PG-FP4-E Datasheet - Page 64

• Manufacturer Part Number: PG-FP4-E
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP4-E

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

62
Caution Set the values of the V
[Vdd [V]]
Displays the default Vdd level set by the parameter file in volts (V).
This Vdd level can be changed by input.
[Vdd2 [V]]
Displays the default Vdd2 level set by the parameter file in volts (V).
If the specifications of the target device require two types of Vdd for writing the flash memory, Vdd2 specifies
a low-level signal voltage. This voltage level can also be changed by input.
[On Target check box]
Check On Target if the V
The power supply detection function of the V
box.
• When V
• When V
If Target V
Setup” is displayed in the communication Log window.
If V
“No VDD applied or Voltage is out of range” is displayed in the communication log window.
DD
is outside the range of ±5% of the V
DD
DD
[V] before checking On Target. The target system may be damaged if proper values are not
set.
is set to be supplied from FP4 (On Target not checked)
is set to be supplied from the target (On Target checked)
DD
reaches 0.2 V before V
CHAPTER 4 PG-FP4 OPERATION USING GUI SOFTWARE
DD
Figure 4-29. Setup Window – Supply Voltage
/V
DD2
voltages are supplied from the target system.
DD
User’s Manual U15260EJ4V0UM
/V
DD2
DD
voltages supplied by the target system as Vdd [V] and Vdd2
is supplied, the error message “Target power detected! Check
DD
DD
set value just before communication starts, the error message
pin differs depending on the setting of the On Target check