D13003TF16V Renesas Electronics America, D13003TF16V Datasheet - Page 113

• Manufacturer Part Number: D13003TF16V
• Description: IC H8/3003 ROMLESS 112QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of D13003TF16V

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SCI
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 50
• Program Memory Type: ROMless
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

•
•
•
•
•
•
•
UE = 0: The I and UI bits in the CPU’s CCR and the IPR bits enable three-level masking of IRQ
to IRQ
•
•
If an interrupt condition occurs and the corresponding interrupt enable bit is set to 1, an
interrupt request is sent to the interrupt controller.
When the interrupt controller receives one or more interrupt requests, it selects the highest-
priority request, following the IPR interrupt priority settings, and holds other requests
pending. If two or more interrupts with the same IPR setting are requested simultaneously, the
interrupt controller follows the priority order shown in table 5-3.
The interrupt controller checks the I bit. If the I bit is cleared to 0, the selected interrupt
request is accepted. If the I bit is set to 1, only NMI is accepted; other interrupt requests are
held pending.
When an interrupt request is accepted, interrupt exception handling starts after execution of
the current instruction has been completed.
In interrupt exception handling, PC and CCR are saved to the stack area. The PC value that is
saved indicates the address of the first instruction that will be executed after the return from
the interrupt service routine.
Next the I bit is set to 1 in CCR, masking all interrupts except NMI.
The vector address of the accepted interrupt is generated, and the interrupt service routine
starts executing from the address indicated by the contents of the vector address.
Interrupt requests with priority level 0 are masked when the I bit is set to 1, and are unmasked
when the I bit is cleared to 0.
Interrupt requests with priority level 1 are masked when the I and UI bits are both set to 1,
and are unmasked when either the I bit or the UI bit is cleared to 0.
For example, if the interrupt enable bits of all interrupt requests are set to 1, IPRA is set to
H'20, and IPRB is set to H'00 (giving IRQ
interrupts), interrupts are masked as follows:
a. If I = 0, all interrupts are unmasked (priority order: NMI > IRQ
b. If I = 1 and UI = 0, only NMI, IRQ
c. If I = 1 and UI = 1, all interrupts are masked except NMI.
7
interrupts and interrupts from the on-chip supporting modules.
2
, and IRQ
2
93
and IRQ
3
are unmasked.
3
interrupt requests priority over other
2
> IRQ
3
>IRQ
0
…).
0