HD64F3048F16 Renesas Electronics America, HD64F3048F16 Datasheet - Page 499

• Manufacturer Part Number: HD64F3048F16
• Description: IC H8 MCU FLASH 128K 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3048F16

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Package: 100PQFP
• Family Name: H8
• Maximum Speed: 16 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 70
• Interface Type: SCI
• On-chip Adc: 8-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 5
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Bit 3—Parity Error (PER): Indicates that data reception ended abnormally due to a parity error
in asynchronous mode.
Notes: 1. Clearing the RE bit to 0 in SCR does not affect the PER flag, which retains its previous
Bit 2—Transmit End (TEND): Indicates that when the last bit of a serial character was
transmitted TDR did not contain new transmit data, so transmission has ended. The TEND flag is
a read-only bit and cannot be written.
Bit 3: PER
0
1
Bit 2: TEND
0
1
2. When a parity error occurs the SCI transfers the receive data into RDR but does not set
value.
the RDRF flag. Serial receiving cannot continue while the PER flag is set to 1. In
synchronous mode, serial transmitting is also disabled.
Description
Receiving is in progress or has ended normally *
[Clearing conditions]
A receive parity error occurred *
[Setting condition]
The number of 1s in receive data, including the parity bit, does not match the
even or odd parity setting of O/E in SMR.
Description
Transmission is in progress
[Clearing conditions]
End of transmission
[Setting conditions]
The chip is reset or enters standby mode.
Software reads PER while it is set to 1, then writes 0.
Software reads TDRE while it is set to 1, then writes 0 in the TDRE flag.
The DMAC writes data in TDR.
The chip is reset or enters standby mode.
The TE bit is cleared to 0 in SCR.
TDRE is 1 when the last bit of a serial character is transmitted.
2
Section 13 Serial Communication Interface
Rev. 3.00 Sep 27, 2006 page 471 of 872
1
REJ09B0325-0300
(Initial value)
(Initial value)