MC68HC908JB16DW Freescale Semiconductor, MC68HC908JB16DW Datasheet - Page 136

• Manufacturer Part Number: MC68HC908JB16DW
• Description: IC MCU 16K FLASH 6MHZ USB 28SOIC
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC68HC908JB16DW

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 6MHz
• Connectivity: SCI, USB
• Peripherals: LED, LVD, POR, PWM
• Number Of I /o: 21
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 28-SOIC (7.5mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -

Monitor ROM (MON)
9.5.1 Extended Security
Technical Data
136
Extended Security
NOTE:
NOT SET
SET
Upon power-on reset, if the received bytes of the security code do not
match the data at locations $FFF6–$FFFD, the host fails to bypass the
security feature. The MCU remains in monitor mode, but reading a
FLASH location returns an invalid value and trying to execute code from
FLASH causes an illegal address reset. After receiving the eight security
bytes from the host, the MCU transmits a break character, signifying that
it is ready to receive a command.
The MCU does not transmit a break character until after the host sends
the eight security bytes.
To determine whether the security code entered is correct, check to see
if bit 6 of RAM address $80 is set. If it is, then the correct security code
has been entered and FLASH can be accessed.
If the security sequence fails, the device should be reset by a power-on
reset and brought up in monitor mode to attempt another entry. After
failing the security sequence, the FLASH module can also be mass
erased by executing an erase routine that was downloaded into internal
RAM. The mass erase operation clears the security code locations so
that all eight security bytes become $FF (blank).
To further disable monitor mode functions, the monitor commands can
be disabled by writing $7B to the FLASH location $FFD1 and $87 to the
FLASH location $FFD0.
affect monitor mode operations.
Monitor Mode Entry Security
Table 9-10. Monitor Mode Security
BYPASSED
BYPASSED
Monitor ROM (MON)
FAILED
FAILED
Table 9-10
Read/write of RAM and FLASH.
Read/write of RAM.
Read of FLASH disabled. FLASH can only
be mass erased.
Read/write of RAM and FLASH disabled.
Read/write of RAM.
Read of FLASH disabled. FLASH can only
be mass erased.
shows the security settings that
Monitor Functions Available
MC68HC908JB16
Freescale Semiconductor
—
Rev. 1.1