CS1W-CN224 Omron, CS1W-CN224 Datasheet - Page 115

• Manufacturer Part Number: CS1W-CN224
• Description: "CABLE,CS1/C200H PRO27,2m"
• Manufacturer: Omron

Specifications of CS1W-CN224

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

• PROFIBUS-DP master class one with support
• 7 kWord I/O
• Simple configuration through FDT/DTM
• Special CPU unit
• Handles data independent of the CPU unit,
The CS1W-PRM21 is a master system (DPM1). It exchanges I/O data
and communication/status information with the CPU of the PLC. To
configure the CS1W-PRM21 a serial port of the CPU can be used. But
because configuring is done through FINS
PROFIBUS-DP Master Unit
Model
CS1W-PRM21
Function
Specifications
CS1W-PRM21
PROFIBUS-DP Master Unit
of DP-V1 data types.
based configurator
thus reducing CPU load
Main function
Unit No.
Maximum number of units mountable per
PLC
Configurator
Supported baud rate(s)
Selectable PROFIBUS address
Maximum number of PROFIBUS slaves
Maximum number of I/O points
Maximum number of I/O points per
PROFIBUS slave
Control and status ares size
Supported Global_Control services
Supported Master-Slave communication
services
Power consumption
Dimensions
Weight
Ambient temperature
Basic PROFIBUS-DP master Class 1
functions plus: DPV1 data types support
0-15
16
FTD/DTM based
All baud rates as specified by the standard
EN50170 Volume 2, the PROFIBUS exten-
sions to EN50170, as well as the standard
IEC61158:
9.6 kBit/s,
19.2 kBit/s,
45.45 kBit/s.
93.75 kBit/s,
187.5 kBit/s,
500 kBit/s,
1.5 MBit/s,
3 MBit/s,
6 MBit/s,
12 MBit/s
0-125
125
7168 words
244 bytes In / 244 bytes Out
25 words
400 mA at 5 V
34.5 mm wide x 130 mm height x
111.2 mm depth
154 gr
Operating: 0 °C to 50 °C
Sync
Unsync
Freeze
Unfreeze
Clear
Data_Exchange
Slave_Diag
Set_PRM
Chk_Cfg
Global_Control
communication virtual any accesspoint on the PLC network can be
used. It exchanges data and commands with PROFIBUS-DP slave
stations over the PROFIBUS network.
Remarks
Special CPU unit
Maximum depends on PLC CPU-type
Incorporates a Generic DTM to use with GSD-file
based slaves
The baud rate value to be used must be selected
through the Configurator.
Set through the configurator
Through Control Area
361