M41ST87WMX6 STMicroelectronics, M41ST87WMX6 Datasheet - Page 19

• Manufacturer Part Number: M41ST87WMX6
• Description: IC SUPERVISOR RTC 160X8 28-SOIC
• Manufacturer: STMicroelectronics
• Type: Clock/Calendar/Supervisorr

Specifications of M41ST87WMX6

• Memory Size: 160B
• Time Format: HH:MM:SS:hh (24 hr)
• Date Format: YY-MM-DD-dd
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 28-SOIC, 28-SOH (8.48mm Width)
• Function: Clock/Calendar/Alarm/Timer Interrupt
• Rtc Memory Size: 160 Byte
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.7 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Rtc Bus Interface: Serial (2-Wire, I2C)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-5370-5; M41ST87WMX6

M41ST87Y, M41ST87W
2.6.2
2.6.3
Note:
2.6.4
2.6.5
Tamper bits (TB1 and TB2)
If the TEB
“Read-only” and is reset only by setting the TEB
register 0Fh.
Tamper interrupt enable bits (TIE1 and TIE2)
If this bit is set to a logic '1,' the IRQ/OUT pin will be activated when a tamper event occurs.
This function is also valid in battery backup if the ABE bit (alarm in battery backup) is also
set to '1' (see
In order to avoid an inadvertent activation of the IRQ/OUT pin due to a prior tamper event,
the flag register (0Fh) should be read prior to clearing and again setting the TEB
Tamper connect mode bit (TCM1 and TCM2)
This bit indicates whether the position of the external switch selected by the user is in the
normally open (TCM
page 20
Tamper polarity mode bits (TPM1 and TPM2)
The state of this bit indicates whether the tamper pin input will be taken high (to V
TPM
and
Figure 16 on page
X
= '1') or low (to V
and
X
bit is set, and a tamper condition occurs, the TB
Figure 16 on page
Figure 15 on page
X
= '1') or normally closed (TCM
SS
21).
if TPM
Doc ID 9497 Rev 9
21).
X
21).
= '0') to trigger a tamper event (see
X
bit to '0.' These bits are located in the flags
X
= '0') position (see
X
bit will be set to '1.' This bit is
Figure 14 on page 20
Operating modes
Figure 14 on
X
OUT
bit.
if
19/54