M41ST87WMX6 STMicroelectronics, M41ST87WMX6 Datasheet - Page 34

• Manufacturer Part Number: M41ST87WMX6
• Description: IC SUPERVISOR RTC 160X8 28-SOIC
• Manufacturer: STMicroelectronics
• Type: Clock/Calendar/Supervisorr

Specifications of M41ST87WMX6

• Memory Size: 160B
• Time Format: HH:MM:SS:hh (24 hr)
• Date Format: YY-MM-DD-dd
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 28-SOIC, 28-SOH (8.48mm Width)
• Function: Clock/Calendar/Alarm/Timer Interrupt
• Rtc Memory Size: 160 Byte
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.7 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Rtc Bus Interface: Serial (2-Wire, I2C)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-5370-5; M41ST87WMX6

Clock operation
Figure 24. Alarm interrupt reset waveform
Table 8.
34/54
ADDRESS POINTER
RPT5
1
1
1
1
1
0
ACTIVE FLAG
IRQ/OUT
alarm condition activates the IRQ/OUT pin as shown in
alarm, write '0' to the alarm date register and to RPT5–RPT1.
If the address pointer is allowed to increment to the flag register address, an alarm condition
will not cause the interrupt/flag to occur until the address pointer is moved to a different
address. It should also be noted that if the last address written is the “alarm seconds,” the
address pointer will increment to the flag address, causing this situation to occur. Thus the
user should not leave the address pointer at 0Fh if using the alarm interrupt function. This is
easily handled by simply reading past the flags registers before teminating a read sequence.
The IRQ/OUT output is cleared by a READ to the flags register. A subsequent READ of the
flags register is necessary to see that the value of the alarm flag has been reset to '0.'
The IRQ/OUT pin can also be activated in the battery backup mode. The IRQ/OUT will go
low if an alarm occurs and both ABE (alarm in battery backup mode enable) and AFE are
set. The ABE and AFE bits are reset during power-up, therefore an alarm generated during
power-up will only set AF. The user can read the flag register at system boot-up to
determine if an alarm was generated while the M41ST87Y/W was in the deselect mode
during power-up.
Alarm repeat modes
RPT4
0Eh
1
1
1
1
0
0
Figure 25 on page 35
RPT3
1
1
1
0
0
0
Doc ID 9497 Rev 9
0Fh
illustrates the backup mode alarm timing.
RPT2
1
1
0
0
0
0
Figure 25 on page
RPT1
1
0
0
0
0
0
M41ST87Y, M41ST87W
HIGH-Z
10h
Once per second
Once per minute
Once per month
Once per hour
Alarm setting
Once per year
Once per day
35. To disable the
AI07086