QW1 TechTools, QW1 Datasheet - Page 149

• Manufacturer Part Number: QW1
• Description: PROGRAMMER PIC MCU QUICKWRITER
• Manufacturer: TechTools
• Series: QuickWriter™r
• Type: QuickWriterr

Specifications of QW1

• Contents: MCU Programmer with In-Circuit Serial Programming Cable and Optional GANG Adapters
• For Use With/related Products: PIC Micro® MCU
• For Use With: CBL-ICSP - CABLE PROG QUICKWRITER SERIALQW-4SSOP18 - ADAPTER QUICKWRITER 4GANG 18SSOPQW-4SSOP28 - ADAPTER QUICKWRITER 4GANG 28SSOPQW-4SO8/14W - ADAPT QUICKWRTR 4GANG 8/14SOIC WQW-4SO8/14N - ADAPT QUICKWRTR 4GANG 8/14SOIC NQW-4SOIC18 - ADAPTER QUICKWRITER 4GANG 18SOICQW-4ZIF18 - ADAPTER QUICKWRITER 4-GANG 18ZIFQW-4SOIC28 - ADAPTER QUICKWRITER 4GANG 28SOICQW-4PLCC44 - ADAPTER QUICKWRITER 4GANG 44PLCCQW-4ZIF40/28 - ADAPT QUICKWRITER 4GANG 40/28ZIFMP-ZIF14 - ADAPTER QUICKWRITER 14-PIN ZIFMP-SOIC8/14 - ADAPTER QUICKWRITER 8/14-SOICMP-SSOP18 - ADAPTER QUICKWRITER 18-SSOPMP-SSOP28 - ADAPTER QUICKWRITER 28-SSOPMP-14000 - ADAPTR QUICKWRTR PIC14000 28-PINMP-SOIC18 - ADAPTER QUICKWRITER 18-SOICMP-SOIC28 - ADAPTER QUICKWRITER 28-SOICMP-PLCC44 - ADAPTER QUICKWRITER 44-PIN PLCCMP-ZIF18/28 - ADAPTER QUICKWRITER 18/28PIN ZIFMP-ZIF40 - ADAPTER QUICKWRITER 40-PIN ZIF

ClearView Assembler
143
You can pause an error list by typing CTRL-S; you can also press ESC or CTRL-C to abort the error
list.
The following error messages may occur during assembly. They will always be preceded
by "ERROR filename xxx", where filename is the file and xxx is the line number where the
error occurred.
Address limit of xxxxh was exceeded:
Data was assembled at an address which exceeded the limit for the given PIC.
Attempt to divide by 0:
An attempt was made to divide a quantity by zero.
Bit number must be from 0 to 7:
A bit-address expression attempted to use a bit number greater than 7.
Data was already entered at location xxxxh:
An object code location which had already been assigned data, was written to again.
Equate directive must be preceded by a symbol:
An "EQU" or "=" directive was not preceded by a necessary symbol.
Illegal mnemonic:
The assembler encountered an unknown directive or instruction.
Include files cannot be nested:
An INCLUDE directive was found in an included file.
Syntax error in operand:
The operand contained an expression which did not follow proper syntax.
Invalid filename for include file: An invalid filename was given in an INCLUDE directive.
Line cannot exceed 256 characters:
Line length exceeded the line limit of 256 characters.
Mnemonic field cannot exceed 7 characters:
More than 7 characters were in the mnemonic (instruction) field.
Illegal mnemonic/operand combination:
The operand structure did not match the instruction’s or directive’s possibilities.
© 2007 TechTools