QW1 TechTools, QW1 Datasheet - Page 150

• Manufacturer Part Number: QW1
• Description: PROGRAMMER PIC MCU QUICKWRITER
• Manufacturer: TechTools
• Series: QuickWriter™r
• Type: QuickWriterr

Specifications of QW1

• Contents: MCU Programmer with In-Circuit Serial Programming Cable and Optional GANG Adapters
• For Use With/related Products: PIC Micro® MCU
• For Use With: CBL-ICSP - CABLE PROG QUICKWRITER SERIALQW-4SSOP18 - ADAPTER QUICKWRITER 4GANG 18SSOPQW-4SSOP28 - ADAPTER QUICKWRITER 4GANG 28SSOPQW-4SO8/14W - ADAPT QUICKWRTR 4GANG 8/14SOIC WQW-4SO8/14N - ADAPT QUICKWRTR 4GANG 8/14SOIC NQW-4SOIC18 - ADAPTER QUICKWRITER 4GANG 18SOICQW-4ZIF18 - ADAPTER QUICKWRITER 4-GANG 18ZIFQW-4SOIC28 - ADAPTER QUICKWRITER 4GANG 28SOICQW-4PLCC44 - ADAPTER QUICKWRITER 4GANG 44PLCCQW-4ZIF40/28 - ADAPT QUICKWRITER 4GANG 40/28ZIFMP-ZIF14 - ADAPTER QUICKWRITER 14-PIN ZIFMP-SOIC8/14 - ADAPTER QUICKWRITER 8/14-SOICMP-SSOP18 - ADAPTER QUICKWRITER 18-SSOPMP-SSOP28 - ADAPTER QUICKWRITER 28-SSOPMP-14000 - ADAPTR QUICKWRTR PIC14000 28-PINMP-SOIC18 - ADAPTER QUICKWRITER 18-SOICMP-SOIC28 - ADAPTER QUICKWRITER 28-SOICMP-PLCC44 - ADAPTER QUICKWRITER 44-PIN PLCCMP-ZIF18/28 - ADAPTER QUICKWRITER 18/28PIN ZIFMP-ZIF40 - ADAPTER QUICKWRITER 40-PIN ZIF

4.2
144
TechTools Instruction Set
ADD, ADDB
AND
CALL
CJA, CJAE
CJB, CJBE
PicTools Manual 3.0
150
151
Literal value must be from 0 to 0FFh:
A value which needed to be from 0 to 255, was greater than 255.
Operand field cannot exceed 256 characters:
More than 256 characters were in the operand field after expansion by the assembler.
Redefinition of symbol xxxx:
An attempt was made to redefine a symbol that was already defined.
Symbol field cannot exceed 32 characters:
More than 32 characters were in the symbol field.
(operand) symbol must contain only letters, numbers, ‘_’, and ‘:’:
A symbol contained illegal characters.
(operand) symbol is a reserved word:
A symbol was identical to a reserved word. The symbols you define must not be reserved
words.
(operand) symbol is too long:
A symbol referenced in the operand exceeded 32 characters.
(operand) symbol must begin with a letter or ‘_’:
A symbol started with an illegal character.
Symbol table full:
The symbol table’s 16K limit was exceeded.
Use of unknown symbol xxxx:
A symbol was referenced in the operand, which was never declared earlier in your
program.
For a listing of the Microchip Instruction set and the equivalent CVASM16 instruction; see
the next section,
152
153
148
"Microchip to CVASM16
145
"
© 2007 TechTools