QW1 TechTools, QW1 Datasheet - Page 41

• Manufacturer Part Number: QW1
• Description: PROGRAMMER PIC MCU QUICKWRITER
• Manufacturer: TechTools
• Series: QuickWriter™r
• Type: QuickWriterr

Specifications of QW1

• Contents: MCU Programmer with In-Circuit Serial Programming Cable and Optional GANG Adapters
• For Use With/related Products: PIC Micro® MCU
• For Use With: CBL-ICSP - CABLE PROG QUICKWRITER SERIALQW-4SSOP18 - ADAPTER QUICKWRITER 4GANG 18SSOPQW-4SSOP28 - ADAPTER QUICKWRITER 4GANG 28SSOPQW-4SO8/14W - ADAPT QUICKWRTR 4GANG 8/14SOIC WQW-4SO8/14N - ADAPT QUICKWRTR 4GANG 8/14SOIC NQW-4SOIC18 - ADAPTER QUICKWRITER 4GANG 18SOICQW-4ZIF18 - ADAPTER QUICKWRITER 4-GANG 18ZIFQW-4SOIC28 - ADAPTER QUICKWRITER 4GANG 28SOICQW-4PLCC44 - ADAPTER QUICKWRITER 4GANG 44PLCCQW-4ZIF40/28 - ADAPT QUICKWRITER 4GANG 40/28ZIFMP-ZIF14 - ADAPTER QUICKWRITER 14-PIN ZIFMP-SOIC8/14 - ADAPTER QUICKWRITER 8/14-SOICMP-SSOP18 - ADAPTER QUICKWRITER 18-SSOPMP-SSOP28 - ADAPTER QUICKWRITER 28-SSOPMP-14000 - ADAPTR QUICKWRTR PIC14000 28-PINMP-SOIC18 - ADAPTER QUICKWRITER 18-SOICMP-SOIC28 - ADAPTER QUICKWRITER 28-SOICMP-PLCC44 - ADAPTER QUICKWRITER 44-PIN PLCCMP-ZIF18/28 - ADAPTER QUICKWRITER 18/28PIN ZIFMP-ZIF40 - ADAPTER QUICKWRITER 40-PIN ZIF

© 2007 TechTools
3.1.7
Let the emulator run for several seconds, and then click the stop button.
Single-Stepping
Select Single Step from the Run menu, or click the equivalent button.
Step 9:
Step 10:
This causes the emulator to run your assembled program.
If all goes well, the status bar should display several quick messages, such as
"downloading code" and "resetting emulator." The final status message should be
"Running..."
Selecting Go is the only way to make the emulator ru n at full hardware speeds (20 MHz,
etc). During full-speed execution, the screen is not updated. To watch changes during
execution, you must select single-step or animate, which are slower modes of execution.
Single-step and animate are shown in the foll owing pages.
After you click the Stop button, you should see something like the screen below. The
highlighted line (green) indicates where program execution stopped.
The status line (which is in the toolbar, but not shown here) will indicate the current
address, such as "User Halted at 000Dh".
F6
TechTools Design Environment
35