DF2437FV Renesas Electronics America, DF2437FV Datasheet - Page 696

• Manufacturer Part Number: DF2437FV
• Description: IC H8S/2437 MCU FLASH 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of DF2437FV

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 85
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 22 Power-Down Modes
22.2.4
Hardware Standby Mode
Transition to Hardware Standby Mode:
When the STBY pin is driven low, a transition is made to hardware standby mode from any mode.
In hardware standby mode, all functions enter the reset state and stop operation, resulting in a
significant reduction in power consumption. As long as the prescribed voltage is supplied, on-chip
RAM data is retained. I/O ports are set to the high-impedance state.
In order to retain on-chip RAM data, the RAME bit in SYSCR should be cleared to 0 before
driving the STBY pin low. Do not change the state of the mode pins (MD2 to MD0) while this
LSI is in hardware standby mode.
Note: Do not set hardware standby mode during a reset at power-on.
Clearing Hardware Standby Mode:
Hardware standby mode is cleared by means of the STBY pin and the RES pin. When the STBY
pin is driven high while the RES pin is low, the reset state is set and clock oscillation is started.
Ensure that the RES pin is held low until the clock oscillator stabilizes (for details on the
oscillation stabilization time, refer to table 22.2). When the RES pin is subsequently driven high, a
transition is made to the program execution state via the reset exception handling state.
Hardware Standby Mode Timing:
Figure 22.3 shows an example of hardware standby mode timing.
When the STBY pin is driven low after the RES pin has been driven low, a transition is made to
hardware standby mode. Hardware standby mode is cleared by driving the STBY pin high, waiting
for the oscillation stabilization time, then changing the RES pin from low to high.
Rev.2.00 May. 28, 2009 Page 656 of 732
REJ09B0059-0200