OM13012,598 NXP Semiconductors, OM13012,598 Datasheet - Page 21

• Manufacturer Part Number: OM13012,598
• Description: BOARD EVAL LPC11C2X
• Manufacturer: NXP Semiconductors

Specifications of OM13012,598

• Featured Product: 32-bit ARM Cortex-M0 Microcontrollers
• Processor To Be Evaluated: LPC11C2x
• Data Bus Width: 32 bit
• Core: ARM Cortex-M0
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 3.3 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-6645; OM13012

NXP Semiconductors
LPC11CX2_CX4
Product data sheet
7.12.1 Features
7.13.1 Features
7.12 10-bit ADC
7.13 General purpose external event counter/timers
to a permanent dominant state (blocking all network communications). The TXD dominant
time-out timer is reset when the CAN_TXD signal is set HIGH. The TXD dominant
time-out time also defines the minimum possible bit rate of 40 kbit/s.
The LPC11Cx2/Cx4 contains one ADC. The ADC is a single 10-bit successive
approximation ADC with eight channels.
The LPC11Cx2/Cx4 includes two 32-bit counter/timers and two 16-bit counter/timers. The
counter/timer is designed to count cycles of the system derived clock. It can optionally
generate interrupts or perform other actions at specified timer values, based on four
match registers. Each counter/timer also includes one capture input to trap the timer value
when an input signal transitions, optionally generating an interrupt.
•
•
•
•
•
•
•
•
•
•
•
•
•
10-bit successive approximation ADC.
Input multiplexing among 8 pins.
Power-down mode.
Measurement range 0 V to V
10-bit conversion time  2.44 s.
Burst conversion mode for single or multiple inputs.
Optional conversion on transition of input pin or timer match signal.
Individual result registers for each ADC channel to reduce interrupt overhead.
A 32-bit/16-bit timer/counter with a programmable 32-bit/16-bit prescaler.
Counter or timer operation.
One capture channel per timer, that can take a snapshot of the timer value when an
input signal transitions. A capture event may also generate an interrupt.
Four match registers per timer that allow:
– Continuous operation with optional interrupt generation on match.
– Stop timer on match with optional interrupt generation.
– Reset timer on match with optional interrupt generation.
Up to four external outputs corresponding to match registers, with the following
capabilities:
– Set LOW on match.
– Set HIGH on match.
– Toggle on match.
– Do nothing on match.
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 3 December 2010
DD
.
32-bit ARM Cortex-M0 microcontroller
LPC11Cx2/Cx4
© NXP B.V. 2010. All rights reserved.
21 of 61