CS1W-CN313 Omron, CS1W-CN313 Datasheet - Page 143

• Manufacturer Part Number: CS1W-CN313
• Description: "CABLE CS1 EXP I/O,30cm"
• Manufacturer: Omron

Specifications of CS1W-CN313

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Wiring and Connections
Terminal Block I/O Units
with Terminal Block
Crimp Connectors
I/O Units with
Connectors
!Caution Crimp connectors are required by UL and CSA standards.
Note Confirm that the terminal block is securely locked before use.
Note Tighten the terminal screws to a torque of 0.5 N • m.
The I/O Unit’s terminal blocks are removable. Make sure that the connector
tabs are locked in the vertical position, as shown in the following diagram.
Although the terminal block position of the CQM1-OC224 is different, the
removal method is the same.
To remove the terminal block, push the connector tabs to the sides and lift the
terminal block off the connector, as shown in the following diagram.
Use M3 crimp connectors of the dimensions shown below for wiring terminal
block-type I/O Units.
Connect either a cable prepared by the user or a dedicated cable to the I/O
Unit connectors.
DC Input Unit
Transistor
Output Unit
Name
Open this tab as widely
as necessary.
32
32
6.2 mm max.
points
No. of
12 V DC (32 points per common)
24 V DC (32 points per common)
4.5 V DC, 16 mA to 26.4 V, 100 mA
24 V DC, 500 mA, PNP
Specifications
6.2 mm max.
Section 4-7
CQM1-ID112
CQM1-ID213
CQM1-ID214
CQM1-OD213
CQM1-OD216
Model
121