CS1W-CN313 Omron, CS1W-CN313 Datasheet - Page 62

• Manufacturer Part Number: CS1W-CN313
• Description: "CABLE CS1 EXP I/O,30cm"
• Manufacturer: Omron

Specifications of CS1W-CN313

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

40
CQM1-CQM1H Comparison
New instructions
Serial communications
ports
Serial communications
modes
Power failure detection
time
Standard accessories
Item
TTIM (TOTALIZING TIMER) instruction,
SEND(90)/RECV(98)/CMND(––) (network
communications) instructions, PMCR
(PROTOCOL MACRO) instruction,
STUP(––) (CHANGE RS-232C SETUP)
instruction and 19 floating-point math
instructions available.
One built-in peripheral port
Supports the following communications: Peripheral bus, Programming Console bus, Host Link,
no-protocol
One built-in RS-
232C port
Serial Commu-
nications Board
(available sepa-
rately): 1 RS-
232C port and
1 RS-422A/485
port
No-protocol
Up to 256 bytes can be sent or received with special instruction. Header codes and end codes
can be set. Transmission delay time setting available.
Host Link
All of the CPU Unit’s I/O memory areas, and the user’s program can be accessed using Host
Link commands.
NT Link
(1:1 mode, 1:N
mode)
Protocol macro
AC power supply: 10 to 25 ms
DC power supply: 5 to 25 ms
Battery Set: CPM2A-BAT01
CQM1H-CPU61/51/21:
Supports Host Link,
no-protocol, NT Link (1:1
mode) and 1:1 Data Link
communications.
CQM1H-CPU11: None
Note Programming
Host Link, no-protocol, 1:1
Data Link, NT Link (1:1
mode, 1:N mode) and proto-
col macro communications
supported.
Data transfer is possible
without program between the
PC and an OMRON PT. The
ratio of PCs to PTs can be
one-to-one or
one-to-many.
The 1:N-mode NT Link
connections are possible
only for the RS-232C port or
RS-422A/485 port on the
Serial Communications
Board.
Protocol macro communica-
tions supported using the
RS-232C port or RS-422A/
485 port on the Serial Com-
munications Board (CQM1H-
CPU51/61 only).
Sending and receiving data
is possible using one
instruction via a user-defined
protocol from the ladder
program.
CQM1H
sole functions support-
ed from a PT (except
when pin 7 on the DIP
switch is OFF).
Con-
The instructions on the left are not supported
by the CQM1.
One built-in
RS-232C port
None
NT Link
(1:1 mode
only)
Not supported ---
Battery Set: C500-BAT08
Supports Host Link and
no-protocol
communications (except
CQM1-CPU11/21-EV1).
CQM1-CPU4@-EV1 also
supports 1:1 Data Link, NT
Link (1:1 mode)
Note CQM1-CPU4@-EV1
---
CQM1-CPU4@-EV1 only
CQM1
supports
ming Console func-
tions from a PT.
Section 1-5
Program-