CS1W-CN313 Omron, CS1W-CN313 Datasheet - Page 15

• Manufacturer Part Number: CS1W-CN313
• Description: "CABLE CS1 EXP I/O,30cm"
• Manufacturer: Omron

Specifications of CS1W-CN313

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Application Precautions
!Caution Failure to observe the following precautions could lead to faulty operation of
the PC or the system, or could damage the PC or PC Units. Always heed
these precautions.
• Fail-safe measures must be taken by the customer to ensure safety in the
• Fail-safe measures must be taken by the customer to ensure safety in the
• Always turn ON power to the PC before turning ON power to the control
• Do not turn OFF the power supply to the PC when data is being trans-
• If the I/O Hold Bit (SR 25212) is turned ON, the outputs from the PC will
• Install the Units properly as specified in the operation manuals. Improper
• Mount Units only after checking terminal blocks and connectors com-
• When assembling the Units or mounting the end cover, be sure to lock
• Be sure to mount the end cover to the rightmost Unit.
• Be sure that all the mounting screws, terminal screws, and cable connec-
• Be sure that the terminal blocks, Memory Units, expansion I/O cables,
• Be sure to confirm the orientation and polarities when connecting terminal
• Leave the label attached to the Unit when wiring. Removing the label may
• Remove the label after the completion of wiring to ensure proper heat dis-
• Wire all connections correctly.
• When supplying power at 200 to 240 V AC from a CQM1-PA216 Power
event of incorrect, missing, or abnormal signals caused by broken signal
lines, momentary power interruptions, or other causes.
event that outputs from Output Units remain ON as a result of internal cir-
cuit failures, which can occur in relays, transistors, and other elements.
system. If the PC power supply is turned ON after the control power sup-
ply, temporary errors may result in control system signals because the
output terminals on DC Output Units and other Units will momentarily turn
ON when power is turned ON to the PC.
ferred. In particular, do not turn OFF the power supply when reading or
writing a Memory Card. Also, do not remove the Memory Card when the
BUSY indicator is lit. To remove a Memory Card, first press the memory
card power supply switch and then wait for the BUSY indicator to go out
before removing the Memory Card.
not be turned OFF and will maintain their previous status when the PC is
switched from RUN or MONITOR mode to PROGRAM mode. Make sure
that the external loads will not produce dangerous conditions when this
occurs. (When operation stops for a fatal error, including those produced
with the FALS(07) instruction, all outputs from Output Unit will be turned
OFF and only the internal output status will be maintained.)
installation of the Units may result in malfunction.
pletely.
them securely as shown in the following illustrations. If they are not prop-
erly locked, desired functionality may not be achieved.
tor screws are tightened to the torque specified in the relevant manuals.
Incorrect tightening torque may result in malfunction.
and other items with locking devices are properly locked into place.
Improper locking may result in malfunction.
blocks and connectors.
result in malfunction if foreign matter enters the Unit.
sipation. Leaving the label attached may result in malfunction.
Supply Unit, always remove the metal jumper from the voltage selector
xv
5