HD64570F16 Renesas Electronics America, HD64570F16 Datasheet - Page 273

• Manufacturer Part Number: HD64570F16
• Description: IC SCA SRL COMM ADAPTER 88QFP
• Manufacturer: Renesas Electronics America

Specifications of HD64570F16

• Applications: ISDN
• Interface: Serial
• Voltage - Supply: 4.75 V ~ 5.25 V
• Package / Case: 88-QFP
• Mounting Type: Surface Mount
• Operating Supply Voltage (typ): 5V
• Operating Supply Voltage (min): 4.5V
• Operating Supply Voltage (max): 5.5V
• Operating Temp Range: -20C to 75C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The state transition diagram for three operating modes of the DMAC (initial state, enable state,
and halt state) is shown in figure 6.7.
When the DE bit of DSR is cleared by the MPU while the DMAC is enabled, the DMAC enters
halt state. Issuing a software abort command at this time causes the DMAC to enter initial state.
In this case, the DMA mode register (DMR), DSR, FCT, and DMA interrupt enable register (DIR)
retain their previous values. Note that software cannot cause the DMAC to enter initial state
directly from enable state.
Mode, address, and data length must not be changed during DMAC halt or enable state. If it is
necessary to change these values, the DMAC must be initialized by a software abort command in
advance. However, after a DMA transfer is completed (see table 6.3, DMAC Operating Modes, in
section 6.4.1, Overview), the DMAC is automatically placed in initial state, and no software abort
commands are necessary.
Hardware reset
Mode
change
Address
write
Figure 6.7 Software Abort and DMAC Operation
Initial
state
DE
(Software)
Transfer
complete
1
Software inhibit
Software abort
Enable
state
Rev. 0, 07/98, page 257 of 453
DE
(Software)
DE
(Software)
0
1
state
Halt