IBM25PPC750FL-GR0133T IBM MICROELECTRONICS, IBM25PPC750FL-GR0133T Datasheet - Page 54

• Manufacturer Part Number: IBM25PPC750FL-GR0133T
• Description: MPU 750xx RISC 32-Bit 0.13um 600MHz 1.8V/2.5V/3.3V 750-Pin CBGA Tray
• Manufacturer: IBM MICROELECTRONICS

Specifications of IBM25PPC750FL-GR0133T

• Package: 750CBGA
• Device Core: PowerPC
• Family Name: 750xx
• Number Of Cpu Cores: 1
• Data Bus Width: 32 Bit
• Maximum Speed: 600 MHz
• I/o Voltage: 1.8|2.5|3.3 V
• Operating Temperature: -40 to 105 °C

Table 5-6. Input/Output Use (Sheet 4 of 4)
TT[0:4]
V
WT
Notes:
750FL Micropro-
DD
1. Depends on the system design. The electrical characteristics of the 750FL microprocessor do not add additional constraints to the system design. Therefore, whatever is
2. HRESET, SRESET, and TRST are signals used for ESP and RISCWatch to enable the correct operation of the debuggers. Logical AND gates must be placed between
3. The 750FL microprocessor provides protection from metastability on inputs through the use of a “keeper” circuit on specific inputs. See Section 5.5 Level Protection on
4. If a system design requires a signal level to be maintained while not being actively driven, an external resistor or device must be used (keepers assure no metastability of
5. The 750FL microprocessor does not require external pullups on address and data lines. Control lines must be treated individually.
cessor Signal
done with the net depends on the system requirements.
these signals and 750FL microprocessor. (See Figure 5-7 IBM RISCWatch JTAG to HRESET, TRST, and SRESET Signal Connector on page 55.)
page 55 for a more detailed description.
inputs but do not guarantee a level).
Name
Active Level
High
Low
Input/Output
Output
Output
Input/
Transfer Attributes
Transfer Attributes
Power Supply
Usage Group
Input/Output with
Pullup Resistors
Internal
Level Protect
Keeper
Keeper
Required
External
Resistor
Comments
1, 3, 4
1, 3, 4
Notes