upd78f0148m1gka1-9eu Renesas Electronics Corporation., upd78f0148m1gka1-9eu Datasheet - Page 167

• Manufacturer Part Number: upd78f0148m1gka1-9eu
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

(3) 16-bit timer output control register 0n (TOC0n)
Note The capture operation is not performed if both the rising and falling edges are specified as the valid edge of
Cautions 1. Timer operation must be stopped before setting CRC01.
This register controls the operation of 16-bit timer/event counter 0n output controller. It sets/resets the timer
output F/F (LV0n), enables/disables output inversion and 16-bit timer/event counter 0n timer output,
enables/disables the one-shot pulse output operation, and sets the one-shot pulse output trigger via software.
TOC0n can be set by a 1-bit or 8-bit memory manipulation instruction.
RESET input clears TOC0n to 00H.
Remark n = 0:
Address: FFB8H
Symbol
CRC01
TI001.
2. When the mode in which clear & start occurs on a match between TM01 and CR001 is
3. To ensure that the capture operation is performed properly, the capture trigger requires a
n = 0, 1:
selected with 16-bit timer mode control register 01 (TMC01), CR001 should not be specified
as a capture register.
pulse longer than two cycles of the count clock selected by prescaler mode register 01
(PRM01).
CRC012
CRC011
CRC010
7
0
0
1
0
1
0
1
Figure 7-9. Format of Capture/Compare Control Register 01 (CRC01)
After reset: 00H
µ
µ
PD780143, 780144
PD780146, 780148, 78F0148
CHAPTER 7 16-BIT TIMER/EVENT COUNTERS 00 AND 01
Operates as compare register
Operates as capture register
Captures on valid edge of TI011
Captures on valid edge of TI001 by reverse phase
Operates as compare register
Operates as capture register
6
0
R/W
User’s Manual U15947EJ3V1UD
5
0
CR011 operating mode selection
CR001 operating mode selection
CR001 capture trigger selection
4
0
3
0
Note
CRC012
2
CRC011
1
CRC010
0
167