at91cap7e ATMEL Corporation, at91cap7e Datasheet - Page 195

• Manufacturer Part Number: at91cap7e
• Description: Customizable Microcontroller
• Manufacturer: ATMEL Corporation

23. Peripheral DMA Controller (PDC)
23.1
8549A–CAP–10/08
Description
The Peripheral DMA Controller (PDC) transfers data between on-chip serial peripherals and the
on- and/or off-chip memories. The link between the PDC and a serial peripheral is operated by
the AHB to ABP bridge.
The PDC contains
nels used in pairs (transmit only or receive only) except the ADC Controller uses only one RX
channel.
The user interface of each PDC channel is integrated into the user interface of the peripheral it
serves. The user interface of mono directional channels (receive only or transmit only), contains
two 32-bit memory pointers and two 16-bit counters, one set (pointer, counter) for current trans-
fer and one set (pointer, counter) for next transfer. The bi-directional channel user interface
contains four 32-bit memory pointers and four 16-bit counters. Each set (pointer, counter) is
used by current transmit, next transmit, current receive and next receive.
Using the PDC removes processor overhead by reducing its intervention during the transfer.
This significantly reduces the number of clock cycles required for a data transfer, which
improves microcontroller performance.
To launch a transfer, the peripheral triggers its associated PDC channels by using transmit and
receive signals. When the programmed data is transferred, an end of transfer interrupt is gener-
ated by the peripheral itself.
The half-duplex peripherals feature 3 bi-directional channels.
22
channels.
The full-duplex peripherals feature 19 mono directional chan-
AT91CAP7E
195