ia186es Innovasic Semiconductor Inc., ia186es Datasheet - Page 59

• Manufacturer Part Number: ia186es
• Description: 8-bit/16-bit Microcontrollers
• Manufacturer: Innovasic Semiconductor Inc.

IA186ES/IA188ES
8-Bit/16-Bit Microcontrollers
4.23
With the exception of word accesses to odd memory locations or between locked memory
addresses, DMA transfers have a higher priority than CPU transfers. Because the CPU cannot
access memory during a DMA transfer and a DMA transfer cannot be suspended by an interrupt
request, continuous DMA activity will increase interrupt delay. An NMI request halts any DMA
activity, however, enabling the CPU to respond promptly to the request.
4.24
TMRIN0, TMRIN1, INT2, and INT4 are internally configured to support the detection of rising
and falling edges on the PWD pin (int2/int0_n/pwd) and to enable either timer0 or timer1,
depending on whether the signal is high or low (see Figure 11). Because they are not used in this
mode, the tmrin0, tmrin1, and int4 pins are available as PIO pins.
Note: There is no support for analog-to-digital conversion. This feature
provides a means of measuring the width of a pulse in both its high and low
phases. Its enabled by the PWD bit (Bit [6]) in the SYSCON.
Whether DMA transfers cease upon reaching a designated count (Bit [9])
Whether the last transfer generates an interrupt (Bit [8])
Synchronization mode (Bits [7–6])
The relative priority of one DMA channel with respect to the other (Bit [5])
Acceptance of DMA requests from Timer2 (Bit [4])
Configuration of DRQ pins as INT (Bit [3])
Byte or Word transfers (Bit [0])
DMA Priority
Pulse Width Demodulation
int2
timer0 enabled
Figure 11. Typical Waveform at the int2/int0_n/pwd pin
®
int4
timer1 enabled
UNCONTROLLED WHEN PRINTED OR COPIED
Page 59 of 154
IA211050902-15
int2
Interrupts generated
December 24, 2008
http://www.Innovasic.com
Customer Support:
Data Sheet
1-888-824-4184