mt9075bpr1 Zarlink Semiconductor, mt9075bpr1 Datasheet - Page 12

• Manufacturer Part Number: mt9075bpr1
• Description: E1 Single Chip Transceiver With Liu
• Manufacturer: Zarlink Semiconductor

Jitter Attenuator (JA)
The MT9075B Jitter Attenuator (JA), which consists of a Phase Locked Loop (PLL) and data FIFO, can be used on
either the transmit or receive side of the interface.
On the transmit side the C4b signal clocks the data into the FIFO, the PLL de-jitters the C4b clock and the resulting
clean C4b signal clocks the data out of the FIFO.
When the JA is selected on the receive side, the extracted clock signal clocks the data into the FIFO. The same
clock feeds the PLL and the resulting de-jittered clock is used to clock the data out of the FIFO.
The JA meets the jitter transfer characteristics as proposed by G.823 and the relevant recommendations as
shown in Figure 8. The JA FIFO depth can be selected to be from 16 to 128 words deep, in multiples of 16 (2-
bit) words. Its read pointer can be centered by changing the JFC bit (address 18H of page 02H) to provide
maximum jitter tolerance. If the read pointer should come within 4 bits of either end of the FIFO, the read clock
frequency will be increased or decreased by 0.0625 UI to correct the situation. The maximum time needed to
centre is T
attenuate jitter.
To ensure normal operation, the JA FIFO depth should be set in software to be larger than the anticipated maximum
UI of input jitter.
Clock Jitter Attenuation Modes
MT9075B has three basic jitter attenuation modes of operation, selected by the BS/LS and BL/FR control pins.
•
•
•
System Bus Synchronous Mode
Line Synchronous Mode
Free-run mode
max
= 3904∗Depth ns, where Depth is the selected JA FIFO depth. During this time the JA will not
MT9075B
Figure 7 - Crystal Oscillator Circuit
Zarlink Semiconductor Inc.
OSC2
OSC1
1MΩ
MT9075B
Note: the 1µH inductor is optional
12
56pF
20MHz
100Ω
39pF
1µH*
Data Sheet