h8s-2138 Renesas Electronics Corporation., h8s-2138 Datasheet - Page 169

• Manufacturer Part Number: h8s-2138
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Interrupts KIN7 to KIN0: Interrupts KIN7 to KIN0 are requested by input signals at pins KIN7
to KIN0. When any of pins KIN7 to KIN0 are used as key-sense inputs, the corresponding
KMIMR bits should be cleared to 0 to enable those key-sense input interrupts. The remaining
unused key-sense input KMIMR bits should be set to 1 to disable those interrupts. Interrupts KIN7
to KIN0 correspond to the IRQ6 interrupt. Interrupt request generation pin conditions, interrupt
request enabling, interrupt control level setting, and interrupt request status indications, are all in
accordance with the IRQ6 interrupt settings.
When pins KIN7 to KIN0 are used as key-sense interrupt input pins, either low-level sensing or
falling-edge sensing must be designated as the interrupt sense condition for the corresponding
interrupt source (IRQ6).
5.3.2
There are 38 sources for internal interrupts from on-chip supporting modules, plus one software
interrupt source (address break).
5.3.3
Table 5.4 shows interrupt exception handling sources, vector addresses, and interrupt priorities.
For default priorities, the lower the vector number, the higher the priority.
Priorities among modules can be set by means of ICR. The situation when two or more modules
are set to the same priority, and priorities within a module, are fixed as shown in table 5.4.
For each on-chip supporting module there are flags that indicate the interrupt request status,
and enable bits that select enabling or disabling of these interrupts. If any one of these is set to
1, an interrupt request is issued to the interrupt controller.
The interrupt control level can be set by means of ICR.
The DTC can be activated by an FRT, TMR, SCI, or other interrupt request. When the DTC is
activated by an interrupt, the interrupt control mode and interrupt mask bits have no effect.
Internal Interrupts
Interrupt Exception Vector Table
Rev. 4.00 Jun 06, 2006 page 115 of 1004
Section 5 Interrupt Controller
REJ09B0301-0400