h8s-2138 Renesas Electronics Corporation., h8s-2138 Datasheet - Page 476

• Manufacturer Part Number: h8s-2138
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Section 15 Serial Communication Interface (SCI, IrDA)
Figure 15.4 shows a sample SCI initialization flowchart.
Rev. 4.00 Jun 06, 2006 page 422 of 1004
REJ09B0301-0400
Set CKE1 and CKE0 bits in SCR
SCR to 1, and set RIE, TIE, TEIE,
Clear TE and RE bits in SCR to 0
Set data transfer format in
<Initialization completed>
1-bit interval elapsed?
Set TE and RE bits in
SMR and SCMR
Set value in BRR
Start initialization
(TE, RE bits 0)
and MPIE bits
Figure 15.4 Sample SCI Initialization Flowchart
Yes
Wait
No
[1]
[2]
[3]
[4]
[1] Set the clock selection in SCR.
[2] Set the data transfer format in SMR
[3] Write a value corresponding to the
[4] Wait at least one bit interval, then
Be sure to clear bits RIE, TIE,
TEIE, and MPIE, and bits TE and
RE, to 0.
When the clock is selected in
asynchronous mode, it is output
immediately after SCR settings are
made.
and SCMR.
bit rate to BRR. This is not
necessary if an external clock is
used.
set the TE bit or RE bit in SCR to 1.
Also set the RIE, TIE, TEIE, and
MPIE bits.
Setting the TE and RE bits enables
the TxD and RxD pins to be used.