ST7FLITE29F2M6TR STMicroelectronics, ST7FLITE29F2M6TR Datasheet - Page 41

• Manufacturer Part Number: ST7FLITE29F2M6TR
• Description: IC MCU 8BIT 8K FLASH 20-SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE29F2M6TR

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE2x
• Core: ST7
• Data Bus Width: 8 bit
• Data Ram Size: 384 B
• Interface Type: SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 15
• Number Of Timers: 3
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: ST7FLIT2-COS/COM, ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 7 Channel / 13 bit, 7 Channel
• For Use With: 497-5858 - EVAL BOARD PLAYBACK ST7FLITE497-5049 - KIT STARTER RAISONANCE ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Table 15. SCIx_PutBuffer
Note: This function is for Polling or Interrupt driven mode.
Caution:
– The application can lose control if the SCI is disabled while using this function in polling
– Take care not to access the user buffer until transmission is complete.
Function Name
Function Prototype
Behaviour Description
Input Parameter 1
Input Parameter 2
Output Parameter
Required Preconditions
Functions called
Postconditions
See also
mode.
Void SCIx_PutBuffer(const unsigned char *PtrToBuffer,
unsigned char NbOfBytes)
Starts transmission from the user buffer. The data trans-
mission will be driven either in Polling or Interrupt driven
mode depending on the mode you selected.
*PtrToBuffer
Start address of the user buffer
NbOfBytes
Number of bytes to be transmitted
None
1. SCIx_Mode must have been called.
2. You must enable the interrupt due to Transmit Data
Ready Flag for the Interrupt driven mode
3. You must select the Polling or Interrupt driven trans-
mission mode in ST7lib_Config.h file.
4. The SCIx_IT_Function must have been called inside
the SCI interrupt subroutine.
SCIx_IsTransmitCompleted
None
None
SCIx_PutBuffer
Function Descriptions
41/235