ST7FLITE29F2M6TR STMicroelectronics, ST7FLITE29F2M6TR Datasheet - Page 85

• Manufacturer Part Number: ST7FLITE29F2M6TR
• Description: IC MCU 8BIT 8K FLASH 20-SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE29F2M6TR

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE2x
• Core: ST7
• Data Bus Width: 8 bit
• Data Ram Size: 384 B
• Interface Type: SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 15
• Number Of Timers: 3
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: ST7FLIT2-COS/COM, ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 7 Channel / 13 bit, 7 Channel
• For Use With: 497-5858 - EVAL BOARD PLAYBACK ST7FLITE497-5049 - KIT STARTER RAISONANCE ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Table 47. I2C_Load_Address
Function Name
Function Prototype
Behaviour Description
Input Parameter 1
Input Parameter 2
Output Parameters
Required Preconditions
Functions called
Postconditions
See also
I2C_Load_Address
Void I2C_Load_Address (unsigned char Addr_Byte,
I2C_Mode_Param Mode_Value)
In master mode, transmits the address byte to select the
slave device.
Addr_Byte
You can select any value from 00 to FFh.
You have to pass one of the below parameters.
I2C_TX_MODE
Enters into transmitter mode after slave address is trans-
mitted.
I2C_RX_MODE
Enters into receiver mode after slave address is transmit-
ted.
I2C_SUB_ADD
You must pass this parameter, if slave sub-address has to
be transmitted.
None
1. I2C_Generate_Start must have been called.
2. In I2C Interrupt driven mode, I2C_IT_Function must
have been called in the Interrupt service routine.
None
If you want to transmit the sub-address (the slave address
where the transmitted data to be received, in case of trans-
mission or the slave address from where data to be trans-
mitted, in case of reception), this function has to be called
again.
None
Function Descriptions
85/235