ST7FLITE29F2M6TR STMicroelectronics, ST7FLITE29F2M6TR Datasheet - Page 71

• Manufacturer Part Number: ST7FLITE29F2M6TR
• Description: IC MCU 8BIT 8K FLASH 20-SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE29F2M6TR

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE2x
• Core: ST7
• Data Bus Width: 8 bit
• Data Ram Size: 384 B
• Interface Type: SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 15
• Number Of Timers: 3
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: ST7FLIT2-COS/COM, ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 7 Channel / 13 bit, 7 Channel
• For Use With: 497-5858 - EVAL BOARD PLAYBACK ST7FLITE497-5049 - KIT STARTER RAISONANCE ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Table 40. SPI_GetBuffer
Note: The above function is only for SPI Interrupt driven mode.
Caution:
– Take care not to access the string until reception is complete.
– Any data received before calling this function is ignored
– The data reception will stop if any error occurs during reception.
Function Name
Function Prototype
Behaviour Description
Input Parameter 1
Input Parameter 2
Output Parameters
Required Preconditions
Functions called
Postconditions
See also
SPI_GetBuffer
Void SPI_GetBuffer (unsigned char *PtrToBuffer, un-
signed char NbOfBytes)
Starts reception of data in the interrupt service routine and
stores it in user defined area for SPI Interrupt driven
mode.
*PtrToBuffer
Start address of the user buffer.
NbOfBytes
Number of bytes to be received.
None
1. The SPI should be configured correctly.
2. You must define the SPI Interrupt driven reception
mode in ST7lib_config.h.
3. You must enable interrupts for this mode.
4. For SPI Interrupt driven mode, SPI_IT_Function must
have been called in the Interrupt service routine.
None
You must call SPI_IsReceptionCompleted after this to
check the reception status.
SPI_IsReceptionCompleted, SPI_GetBuffer (SPI Polling
mode)
Function Descriptions
71/235