ST7FLITE29F2M6TR STMicroelectronics, ST7FLITE29F2M6TR Datasheet - Page 92

• Manufacturer Part Number: ST7FLITE29F2M6TR
• Description: IC MCU 8BIT 8K FLASH 20-SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE29F2M6TR

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE2x
• Core: ST7
• Data Bus Width: 8 bit
• Data Ram Size: 384 B
• Interface Type: SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 15
• Number Of Timers: 3
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: ST7FLIT2-COS/COM, ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 7 Channel / 13 bit, 7 Channel
• For Use With: 497-5858 - EVAL BOARD PLAYBACK ST7FLITE497-5049 - KIT STARTER RAISONANCE ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Function Descriptions
Table 54. I2C_GetByte
Notes:
– The above function is for I2C Polling or I2C Interrupt driven mode.
– It is recommended to use a timeout protection when using this function.
– To terminate communication after receiving one byte using I2C_GetByte, you have to man-
92/235
Function Name
Function Prototype
Behaviour Description
Input Parameters
Output Parameters
Required Preconditions
Functions called
Postconditions
See also
age ACK bit and STOP generation as shown in the introduction.
I2C_GetByte
Unsigned char I2C_GetByte (void)
Returns the most recent Byte received in I2C Polling or
I2C interrupt driven mode.
None
Unsigned char
Returns the received data byte.
1. I2C_Load_Address must have been called if master re-
ceiver.
2. You must define I2C Polling or I2C interrupt driven re-
ception mode in ST7lib_config.h.
3. I2C_IsReceptionCompleted must have been called to
ensure that there are no pending requests and also to
check if data byte has been received or not.
4. You must enable interrupts for I2C interrupt driven
mode.
5. In I2C Interrupt driven mode, I2C_IT_Function must
have been called in the Interrupt service routine.
None
None
None