SAK-TC1736-128F80HL AA Infineon Technologies, SAK-TC1736-128F80HL AA Datasheet - Page 56

• Manufacturer Part Number: SAK-TC1736-128F80HL AA
• Description: IC MCU 32BIT 1MB FLASH 144LQFP
• Manufacturer: Infineon Technologies
• Series: TC17xxr

Specifications of SAK-TC1736-128F80HL AA

• Core Processor: TriCore
• Core Size: 32-Bit
• Speed: 80MHz
• Connectivity: ASC, CAN, MLI, MSC, SSC
• Peripherals: DMA, POR, WDT
• Number Of I /o: 70
• Program Memory Size: 1MB (1M x 8)
• Program Memory Type: FLASH
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 1.42 V ~ 1.58 V
• Data Converters: A/D 24x12b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 144-LFQFP
• Packages: PG-LQFP-144
• Max Clock Frequency: 80.0 MHz
• Sram (incl. Cache): 48.0 KByte
• Can Nodes: 2
• A / D Input Lines (incl. Fadc): 24
• Program Memory: 1.0 MB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

2.6.3
Two main use cases are catered for by resources in addition the OCDS Level 1
infrastructure: Overlay of non-volatile on-chip memory and non-intrusive signaling:
•
•
•
•
•
•
•
•
2.6.4
Three options exist for the communication channel between Tools (e.g. Debugger,
Calibration Tool) and TC1736:
•
•
•
•
•
•
•
•
Data Sheet
Intro, V1.1
4 KB SRAM for Overlay.
Can be split into up to 16 blocks which can overlay independent regions of on-chip
Data Flash.
Changing the configuration is triggered by a single SFR access to maintain
consistency.
Overlay configuration switch does not require the TriCore to be stopped or
suspended.
Invalidation of the Data Cache (maintaining write-back data) can be done
concurrently with the same SFR.
256 KB additional Overlay RAM on Emulation Device, shared with the trace
functionality.
A dedicated trigger SFR with 32 independent status bits is provided to centrally post
requests from application code to the host computer.
The host is notified automatically when the trigger SFR is updated by the TriCore. No
polling via a system bus is required.
Two wire DAP (Device Access Port) protocol for long connections or noisy
environments.
Four (or five) wire JTAG (IEEE 1149.1) for standardized manufacturing tests.
CAN (plus software linked into the application code) for low bandwidth deeply
embedded purposes.
DAP and JTAG are clocked by the tool.
Bit clock up to 40 MHz for JTAG, up to 80 MHz for DAP.
Hot attach (i.e. physical disconnect/reconnect of the host connection without reset of
the TC1736) for all interfaces.
Infineon standard DAS (Device Access Server) implementation for seamless,
transparent tool access over any supported interface.
Lock mechanism to prevent unauthorized tool access to critical application code.
Calibration Support
Tool Interfaces
52
Introduction
V1.1, 2009-08
TC1736