P89LPC932A1FA NXP Semiconductors, P89LPC932A1FA Datasheet - Page 10

• Manufacturer Part Number: P89LPC932A1FA
• Description: MCU 8-Bit 89LP 80C51 CISC 8KB Flash 2.5V/3.3V 28-Pin PLCC Tube
• Manufacturer: NXP Semiconductors

Specifications of P89LPC932A1FA

• Package: 28PLCC
• Device Core: 80C51
• Family Name: 89LP
• Maximum Speed: 18 MHz
• Operating Supply Voltage: 2.5|3.3 V
• Data Bus Width: 8 Bit
• Number Of Programmable I/os: 26
• Interface Type: I2C/SPI/UART
• Number Of Timers: 2
• Ram Size: 768 Byte
• Program Memory Size: 8 KB
• Program Memory Type: Flash
• Operating Temperature: -40 to 85 °C

NXP Semiconductors
Table 2.
[1]
P89LPC932A1_3
Product data sheet
Symbol
P2.7/ICA
P3.0 to P3.1
P3.0/XTAL2/
CLKOUT
P3.1/XTAL1
V
V
SS
DD
Input/Output for P1.0 to P1.4, P1.6, P1.7. Input for P1.5.
Pin description
Pin
TSSOP28,
PLCC28,
DIP28
28
9
8
7
21
…continued
HVQFN28
24
5
4
3
17
Type Description
I/O
I
I/O
I/O
O
O
I/O
I
I
I
P2.7 — Port 2 bit 7.
ICA — Input Capture A.
Port 3: Port 3 is a 2-bit I/O port with a user-configurable output type.
During reset Port 3 latches are configured in the input only mode with the
internal pull-up disabled. The operation of Port 3 pins as inputs and
outputs depends upon the port configuration selected. Each port pin is
configured independently. Refer to
and
All pins have Schmitt trigger inputs.
Port 3 also provides various special functions as described below:
P3.0 — Port 3 bit 0.
XTAL2 — Output from the oscillator amplifier (when a crystal oscillator
option is selected via the flash configuration.
CLKOUT — CPU clock divided by 2 when enabled via SFR bit (ENCLK -
TRIM.6). It can be used if the CPU clock is the internal RC oscillator,
watchdog oscillator or external clock input, except when XTAL1/XTAL2 are
used to generate clock source for the RTC/system timer.
P3.1 — Port 3 bit 1.
XTAL1 — Input to the oscillator circuit and internal clock generator circuits
(when selected via the flash configuration). It can be a port pin if internal
RC oscillator or watchdog oscillator is used as the CPU clock source, and
if XTAL1/XTAL2 are not used to generate the clock for the RTC/system
timer.
Ground: 0 V reference.
Power supply: This is the power supply voltage for normal operation as
well as Idle and Power-down modes.
Rev. 03 — 12 March 2007
8-bit microcontroller with accelerated two-clock 80C51 core
Table 8 “Static characteristics”
Section 7.13.1 “Port configurations”
for details.
P89LPC932A1
© NXP B.V. 2007. All rights reserved.
10 of 64