PIC16F1526T-I/PT Microchip Technology, PIC16F1526T-I/PT Datasheet - Page 95

• Manufacturer Part Number: PIC16F1526T-I/PT
• Description: 64-pin, 14KB Flash, 768B RAM, 10-bit ADC, 10xCCP, 2xSPI, 2xMI2C, 2xEUSART, 2.3V-
• Manufacturer: Microchip Technology
• Series: PIC® XLP™ 16Fr

Specifications of PIC16F1526T-I/PT

• Core Processor: PIC
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 54
• Program Memory Size: 14KB (8K x 14)
• Program Memory Type: FLASH
• Eeprom Size: -
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 2.3 V ~ 5.5 V
• Data Converters: A/D 30x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-TQFP
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

9.0
The PIC16F1526/27 has an internal Low Dropout
Regulator (LDO) which provides operation above 3.6V.
The LDO regulates a voltage for the internal device
logic while permitting the V
at a higher voltage. There is no user enable/disable
control available for the LDO, it is always active. The
PIC16LF1526/27 operates at a maximum V
and does not incorporate an LDO.
A device I/O pin may be configured as the LDO voltage
output, identified as the V
required, an external low-ESR capacitor may be con-
nected to the V
The VCAPEN bit of Configuration Word 2 enables the
V
TABLE 9-1:
TABLE 9-2:
 2011 Microchip Technology Inc.
CONFIG2
Legend:
Note 1:
CAP
Name
pin. Refer to
VCAPEN
LOW DROPOUT (LDO)
VOLTAGE REGULATOR
— = unimplemented locations read as ‘0’. Shaded cells are not used by LDO.
PIC16F1526/27 only.
0
1
Bits
13:8
7:0
CAP
VCAPEN SELECT BIT
SUMMARY OF CONFIGURATION WORD WITH LDO
Table
pin for additional regulator stability.
Bit -/7
—
9-1.
DD
—
CAP
and I/O pins to operate
Bit -/6
—
pin. Although not
No Vcap
RF0
Pin
Bit 13/5
DD
LVP
—
of 3.6V
Preliminary
VCAPEN
Bit 12/4
DEBUG
(1)
On power-up, the external capacitor will load the LDO
voltage regulator. To prevent erroneous operation, the
device is held in Reset while a constant current source
charges the external capacitor. After the cap is fully
charged, the device is released from Reset. For more
information on recommended capacitor values and the
constant current rate, refer to the LDO Regulator
Characteristics Table in Section 25.0 “Electrical
Specifications”.
Bit 11/3
LPBOR
—
PIC16(L)F1526/27
Bit 10/2
BORV
—
STVREN
Bit 9/1
WRT<1:0>
Bit 8/0
DS41458B-page 95
—
Register
on Page
48