W83977EF Winbond Electronics Corp America, W83977EF Datasheet - Page 98

• Manufacturer Part Number: W83977EF
• Description: Description = W83877TF Plus Kbc, GP I/O, Wake-Up, Power Fail Resume ;; Package = QFP 128
• Manufacturer: Winbond Electronics Corp America

10.2 Logical Device 0 (FDC)
CR30 (Default 0x01 if PNPCSV# = 0 during POR, default 0x00 otherwise)
CR60, CR 61 (Default 0x03, 0xf0 if PNPCSV# = 0 during POR, default 0x00, 0x00 otherwise)
CR70 (Default 0x06 if PNPCSV# = 0 during POR, default 0x00 otherwise)
CR74 (Default 0x02 if PNPCSV# = 0 during POR, default 0x04 otherwise)
CRF0 (Default 0x0E)
FDD Mode Register
Bit 7 - 1: Reserved.
Bit 0: = 1 Activates the logical device.
These two registers select FDC I/O base address [0x100:0xFF8] on 8 byte boundary.
Bit 7 - 4: Reserved.
Bit 3 - 0: These bits select IRQ resource for FDC.
Bit 7 - 3: Reserved.
Bit 2 - 0: These bits select DRQ resource for FDC.
Bit 7: FIPURDWN
This bit controls the internal pull-up resistors of the FDC input pins RDATA, INDEX, TRAK0,
DSKCHG, and WP.
Bit 6: INTVERTZ
This bit determines the polarity of all FDD interface signals.
Bit 5: DRV2EN (PS2 mode only)
When this bit is a logic 0, this indicates that a second drive is installed and is reflected in status
register A.
Bit 4: Swap Drive 0, 1 Mode
= 0 Logical device is inactive.
= 0x00 DMA0
= 0x01 DMA1
= 0x02 DMA2
= 0x03 DMA3
= 0x04 - 0x07 No DMA active
= 0
= 1
= 0
= 1
= 0
= 1
No Swap (Default)
Drive and Motor sel 0 and 1 are swapped.
The internal pull-up resistors of FDC are turned on.(Default)
The internal pull-up resistors of FDC are turned off.
FDD interface signals are active low.
FDD interface signals are active high.
-92 -
Publication Release Date: April 2003
W83977EF
Revision 1.1