saa569x NXP Semiconductors, saa569x Datasheet - Page 71

• Manufacturer Part Number: saa569x
• Description: Enhanced Tv Microcontrollers With On-screen Display Osd
• Manufacturer: NXP Semiconductors

Philips Semiconductors
23.4
The display can be configured for either 50/60 Hz or 100/120 Hz (2H/2V only) using the display configuration
MMR 87FFH.
Table 29 Display timing modes
23.4.1
This mode enables two different pages to be displayed
side-by-side for use with 16 : 9 TV screens. The display
section clock runs at 24 MHz in this mode. Figure 30
shows the combination of two-page display possible on
the SAA567x; SAA569x device.
Two page mode is selected using MMR 87FFH bit 0. The
two pages displayed are separated by two character
spaces to allow the display logic to switch correctly from
one window to the other. The facility is restricted to 1H/1V
(i.e. 50/60Hz display TVs).
Two control bits exist in double window mode to select
Closed Caption display or text display in each window:
TXT21.CC/TXT for Page A and TXT28.CC_TXT B for
Page B.
TXT: When displaying two Teletext pages side by side, the
memory block being displayed in Page A is selected using
SFR TXT14<3:0> and for Page B using SFR TXT28<3:0>.
The Data Capture section writes the header and time
information only to the memory block corresponding to the
active page. This active page is determined with the
TXT28.ACTIVE PAGE bit. When set to logic 0, Page A is
active, set to logic 1, Page B is active.
2002 May 06
100 Hz BIT
Enhanced TV microcontrollers with
On-Screen Display (OSD)
X
0
1
Display timing modes
DISPLAY TIMING
D
(MMR 87FFH)
OUBLE WINDOW OPERATION
TWO_PAGE BIT
0
1
0
HSYNC/VSYNC RATE
SUPPORTED
1H/1V; 2H/2V
1H/1V
1H/1V
71
Operation of the REVEAL bit (TXT7.5) and CURSOR ON
bit (TXT7.6) only affects the active page.
CC: When CC display mode is selected in two page mode,
only one window may be used for CC/OSD and the other
either Text or Video. Two page CC display (either captions
or OSD) side-by-side is not possible because there is only
one area of memory available for the CC data.
23.4.2
At reset, the device defaults to single window mode, which
corresponds to 87FFH bit 0 set to logic 0. In this mode, the
settings applying to the window displayed are those that
would apply to Page A in double window mode.
For 2H/2V display TVs, the 100 Hz-bit and MMR 87FFH
bit 1, must be set to logic 1 to fit a whole display window.
For 1H/1V display TVs, when MMR 87FFH bit 1 is set to
logic 0, the display window occupies the whole screen,
whereas if MMR 87FFH bit 1 is set to logic 1, only half the
screen would be occupied by the display window. This
latter configuration would give the same kind of display as
in the double window mode with Page A: CC or
Text Page B: Video.
DISPLAY CLOCK
12 MHz
24 MHz
24 MHz
S
INGLE WINDOW OPERATION
SAA567x; SAA569x
NUMBER OF CHARACTERS
80 (double window)
40 (single window)
40 (single window)
Objective specification