S9S12GN16F0VLF Freescale Semiconductor, S9S12GN16F0VLF Datasheet - Page 1020

• Manufacturer Part Number: S9S12GN16F0VLF
• Description: 16-bit Microcontrollers - MCU 16-bit16k Flash 2k RAM
• Manufacturer: Freescale Semiconductor

Specifications of S9S12GN16F0VLF

• Rohs: yes
• Core: S12
• Processor Series: MC9S12G
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 25 MHz
• Program Memory Size: 16 KB
• Data Ram Size: 1024 B
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: TSSOP-20
• Mounting Style: SMD/SMT

96 KByte Flash Module (S12FTMRG96K1V1)
28.4.6.8
The Erase Flash Block operation will erase all addresses in a P-Flash or EEPROM block.
Upon clearing CCIF to launch the Erase Flash Block command, the Memory Controller will erase the
selected Flash block and verify that it is erased. The CCIF flag will set after the Erase Flash Block
operation has completed.
28.4.6.9
The Erase P-Flash Sector operation will erase all addresses in a P-Flash sector.
Upon clearing CCIF to launch the Erase P-Flash Sector command, the Memory Controller will erase the
selected Flash sector and then verify that it is erased. The CCIF flag will be set after the Erase P-Flash
Sector operation has completed.
1022
1
2
As defined by the memory map for FTMRG96K1.
As found in the memory map for FTMRG96K1.
Register
FSTAT
Erase Flash Block Command
Erase P-Flash Sector Command
CCOBIX[2:0]
Table 28-48. Erase P-Flash Sector Command FCCOB Requirements
CCOBIX[2:0]
Table 28-46. Erase Flash Block Command FCCOB Requirements
MGSTAT1
MGSTAT0
ACCERR
Error Bit
000
001
FPVIOL
Table 28-47. Erase Flash Block Command Error Handling
000
001
MC9S12G Family Reference Manual,
Global address [15:0] anywhere within the sector to be erased.
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see
Set if an invalid global address [17:16] is supplied
Set if the supplied P-Flash address is not phrase-aligned or if the EEPROM
address is not word-aligned
Set if an area of the selected Flash block is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Refer to
Global address [15:0] in Flash block to be erased
2
0x0A
0x09
Section 28.1.2.1
FCCOB Parameters
FCCOB Parameters
Global address [17:16] to identify
for the P-Flash sector size.
Error Condition
P-Flash block to be erased
Global address [17:16] to
identify Flash block
Rev.1.23
1
Table
28-27)
Freescale Semiconductor
2