NAND01GW4B2AN6E STMicroelectronics, NAND01GW4B2AN6E Datasheet - Page 17

• Manufacturer Part Number: NAND01GW4B2AN6E
• Description: IC FLASH 1GBIT 48TSOP
• Manufacturer: STMicroelectronics

Specifications of NAND01GW4B2AN6E

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 1G (64M x 16)
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -

NAND01G-B, NAND02G-B
3
3.1
3.2
3.3
3.4
3.5
3.6
Signal descriptions
See
connected to this device.
Inputs/Outputs (I/O0-I/O7)
Input/Outputs 0 to 7 are used to input the selected address, output the data during a Read
operation or input a command or data during a Write operation. The inputs are latched on
the rising edge of Write Enable. I/O0-I/O7 are left floating when the device is deselected or
the outputs are disabled.
Inputs/Outputs (I/O8-I/O15)
Input/Outputs 8 to 15 are only available in x16 devices. They are used to output the data
during a Read operation or input data during a Write operation. Command and Address
Inputs only require I/O0 to I/O7.
The inputs are latched on the rising edge of Write Enable. I/O8-I/O15 are left floating when
the device is deselected or the outputs are disabled.
Address Latch Enable (AL)
The Address Latch Enable activates the latching of the Address inputs in the Command
Interface. When AL is high, the inputs are latched on the rising edge of Write Enable.
Command Latch Enable (CL)
The Command Latch Enable activates the latching of the Command inputs in the Command
Interface. When CL is high, the inputs are latched on the rising edge of Write Enable.
Chip Enable (E)
The Chip Enable input activates the memory control logic, input buffers, decoders and
sense amplifiers. When Chip Enable is low, V
high, v
mode.
Read Enable (R)
The Read Enable pin, R, controls the sequential data output during Read operations. Data
is valid t
column address counter by one.
Figure 2: Logic
IH
RLQV
, while the device is busy, the device remains selected and does not go into standby
after the falling edge of R. The falling edge of R also increments the internal
Diagram, and
Table 3: Signal
IL
, the device is selected. If Chip Enable goes
Names, for a brief overview of the signals
Signal descriptions
17/64