MC912DG128ACPV Freescale Semiconductor, MC912DG128ACPV Datasheet - Page 172

• Manufacturer Part Number: MC912DG128ACPV
• Description: IC MCU 128K FLASH 8MHZ 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912DG128ACPV

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, I²C, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 112-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Clock Functions
12.6.9 Pseudo-STOP exit in Limp Home mode with Delay
12.6.10 Pseudo-STOP exit in Limp Home mode without Delay (Fast Stop Recovery)
Technical Data
172
CAUTION:
(NOLHM=0, CME=X, DLY=1)
When coming out of Pseudo-STOP mode with the NOLHM bit cleared
and the DLY bit set, the MCU goes into limp-home mode (regardless of
the state of the CME or FCME bits).
The VCO supplies the limp-home clock frequency to the 13-stage
counter (XCLK). The BCSP output is forced high and MCS is forced low.
After the 13-stage counter reaches a count of 4096 XCLK cycles, a
check of the clock monitor is performed and as the crystal oscillator was
kept running due to the Pseudo-stop mode, the MCU exits STOP
normally, using the EXTALi clock. In the case where a crystal failure
occurred during pseudo-stop, then the MCU exits STOP using the limp
home clock (f
home interrupt request set to indicate it is not operating at the desired
frequency. Each time the 13-stage counter reaches a count of 4096
XCLK cycles, a check of the clock monitor is performed. If the clock
monitor indicates the presence of an external clock, limp-home mode is
de-asserted, the LHOME flag is cleared and the LHIF limp-home
interrupt request is set to indicate a return to normal operation using
EXTALi clock.
(NOLHM=0, CME=X, DLY=0)
If Pseudo-STOP is exited with the NOLHM bit set to 0 and the DLY bit is
cleared then the exit from Pseudo-STOP is accomplished without delay
as in Fast STOP recovery.
Where Pseudo-STOP recovers using the Limp Home Clock the VCO -
which has been held in STOP - must be restarted in order to supply the
limp home frequency. This restart, which occurs at a high frequency and
ramps toward the limp home frequency, is almost immediately supplied
to the CPU before it may have reached the steady state frequency. It is
possible that the initial clock frequency may be high enough to cause the
CPU to function incorrectly with a resultant risk of code runaway.
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
VCOMIN
Clock Functions
) with both the LHOME flag set and the LHIF limp-
MC68HC912DT128A — Rev 4.0
MOTOROLA