MC912DG128ACPV Freescale Semiconductor, MC912DG128ACPV Datasheet - Page 295

• Manufacturer Part Number: MC912DG128ACPV
• Description: IC MCU 128K FLASH 8MHZ 112-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC12r

Specifications of MC912DG128ACPV

• Core Processor: CPU12
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: CAN, I²C, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x8/10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 112-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

MC68HC912DT128A — Rev 4.0
MOTOROLA
SPE — SPI System Enable
SWOM — Port S Wired-OR Mode
MSTR — SPI Master/Slave Mode Select
CPOL, CPHA — SPI Clock Polarity, Clock Phase
SSOE — Slave Select Output Enable
LSBF — SPI LSB First enable
When MODF is set, SPE always reads zero. SP0CR1 must be written
as part of a mode fault recovery sequence.
Controls not only SPI output pins but also the general-purpose output
pins (PS[4:7]) which are not used by SPI.
When MODF is set, MSTR always reads zero. SP0CR1 must be
written as part of a mode fault recovery sequence.
These two bits are used to specify the clock format to be used in SPI
operations. When the clock polarity bit is cleared and data is not being
transferred, the SCK pin of the master device is low. When CPOL is
set, SCK idles high. See
The SS output feature is enabled only in the master mode by
asserting the SSOE and DDRS7.
Normally data is transferred most significant bit first.This bit does not
affect the position of the MSB and LSB in the data register. Reads and
writes of the data register will always have MSB in bit 7.
Freescale Semiconductor, Inc.
For More Information On This Product,
1 = Hardware interrupt sequence is requested each time the SPIF
0 = SPI internal hardware is initialized and SPI system is in a low-
1 = PS[4:7] are dedicated to the SPI function
0 = SPI and/or PS[4:7] output buffers operate normally
1 = SPI and/or PS[4:7] output buffers behave as open-drain
0 = Slave mode
1 = Master mode
0 = Data is transferred most significant bit first
1 = Data is transferred least significant bit first
or MODF status flag is set
power disabled state.
outputs
Go to: www.freescale.com
Multiple Serial Interface
Figure 16-4
and
Figure
Serial Peripheral Interface (SPI)
16-5.
Multiple Serial Interface
Technical Data
295