SI1005-C-GM Silicon Laboratories Inc, SI1005-C-GM Datasheet - Page 190

• Manufacturer Part Number: SI1005-C-GM
• Description: IC TXRX MCU + EZRADIOPRO
• Manufacturer: Silicon Laboratories Inc

Specifications of SI1005-C-GM

• Package / Case: 42-QFN
• Frequency: 240MHz ~ 960MHz
• Data Rate - Maximum: 256kbps
• Modulation Or Protocol: FSK, GFSK, OOK
• Applications: General Purpose
• Power - Output: 13dBm
• Sensitivity: -121dBm
• Voltage - Supply: 0.9 V ~ 1.8 V
• Current - Receiving: 18.5mA
• Current - Transmitting: 30mA
• Data Interface: PCB, Surface Mount
• Memory Size: 32kB Flash, 4kB RAM
• Antenna Connector: PCB, Surface Mount
• Number Of Receivers: 1
• Number Of Transmitters: 1
• Wireless Frequency: 240 MHz to 960 MHz
• Interface Type: UART, SMBus, SPI, PCA
• Output Power: 13 dBm
• Operating Supply Voltage: 0.9 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Maximum Supply Current: 4.1 mA
• Minimum Operating Temperature: - 40 C
• Modulation: FSK, GFSK, OOK
• Protocol Supported: C2, SMBus
• Core: 8051
• Program Memory Type: Flash
• Program Memory Size: 32 KB
• Data Ram Size: 4352 B
• Supply Current (max): 4.1 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1875-5

Si1000/1/2/3/4/5
20. SmaRTClock (Real Time Clock)
Si1000/1/2/3/4/5 devices include an ultra low power 32-bit SmaRTClock Peripheral (Real Time Clock) with
alarm. The SmaRTClock has a dedicated 32 kHz oscillator that can be configured for use with or without a
crystal. No external resistor or loading capacitors are required. The on-chip loading capacitors are pro-
grammable to 16 discrete levels allowing compatibility with a wide range of crystals. The SmaRTClock can
operate directly from a 0.9–3.6 V battery voltage and remains operational even when the device goes into
its lowest power down mode.
The SmaRTClock allows a maximum of 36 hour 32-bit independent time-keeping when used with a
32.768 kHz Watch Crystal. The SmaRTClock provides an Alarm and Missing SmaRTClock events, which
could be used as reset or wakeup sources. See Section “18. Reset Sources” on page 175 and Section
“14. Power Management” on page 151 for details on reset sources and low power mode wake-up sources,
respectively.
20.1. SmaRTClock Interface
The SmaRTClock Interface consists of three registers: RTC0KEY, RTC0ADR, and RTC0DAT. These inter-
face registers are located on the CIP-51’s SFR map and provide access to the SmaRTClock internal regis-
ters listed in Table 20.1. The SmaRTClock internal registers can only be accessed indirectly through the
SmaRTClock Interface.
190
XTAL4
Registers
Programmable Load Capacitors
Internal
SmaRTClock State Machine
SmaRTClock Oscillator
Figure 20.1. SmaRTClock Block Diagram
CAPTUREn
RTC0XCN
RTC0XCF
RTC0PIN
ALARMn
RTC0CN
XTAL3
Wake-Up
Interrupt
Rev. 1.0
RTC0KEY
RTC0ADR
RTC0DAT
Registers
Interface
SmaRTClock
SmaRTClock
32-Bit
Timer
Power/
Clock
Mgmt