MT29C4G48MAZAPAKD-5 IT Micron Technology Inc, MT29C4G48MAZAPAKD-5 IT Datasheet - Page 54

• Manufacturer Part Number: MT29C4G48MAZAPAKD-5 IT
• Description: MICMT29C4G48MAZAPAKD-5_IT 4G+2G MCP
• Manufacturer: Micron Technology Inc

GET FEATURES (EEh)
Figure 32: GET FEATURES (EEh) Operation
PDF: 09005aef83ba4387
168ball_nand_lpddr_j42p_j4z2_j4z3_omap.pdf – Rev. H 3/11
The GET FEATURES (EEh) command reads the subfeature parameters (P1–P4) from the
specified feature address. This command is accepted by the target only when all die
(LUNs) on the target are idle.
Writing EEh to the command register puts the target in get features mode. The target
stays in this mode until another valid command is issued.
When the EEh command is followed by a feature address, the target goes busy for
t
tion, the READ MODE (00h) command must be used to re-enable data output mode.
After
eters.
Cycle type
FEAT. If the READ STATUS (70h) command is used to monitor for command comple-
R/B#
I/Ox
t
FEAT completes, the host enables data output mode to read the subfeature param-
Command
EEh
168-Ball NAND Flash and LPDDR PoP (TI OMAP) MCP
Address
FA
t WB
54
t FEAT
Micron Technology, Inc. reserves the right to change products or specifications without notice.
t RR
D
P1
OUT
D
P2
OUT
Feature Operations
© 2009 Micron Technology, Inc. All rights reserved.
D
P3
OUT
D
P4
OUT