SAM7L128 Atmel Corporation, SAM7L128 Datasheet - Page 343

• Manufacturer Part Number: SAM7L128
• Manufacturer: Atmel Corporation

Specifications of SAM7L128

• Flash (kbytes): 128 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 36 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 80
• Ext Interrupts: 80
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Segment Lcd: 40
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 460
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 6
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.8 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

29.9.5.6
Figure 29-28. Clock Synchronization in Write Mode
Notes:
6257A–ATARM–20-Feb-08
TWI_RHR
TXCOMP
SVREAD
SCLWS
RXRDY
SVACC
TWCK
1. At the end of the read sequence, TXCOMP is set after a STOP or after a REPEATED_START + an address different from
2. SCLWS is automatically set when the clock synchronization mechanism is started and automatically reset when the mecha-
TWD
SADR.
nism is finished.
Clock Synchronization in Write Mode
S
SADR
As soon as a START is detected
The c lock is tied lo w if the shift register and the TWI_RHR is full. If a STOP or
REPEATED_START condition was not detected, it is tied low until TWI_RHR is read.
Figure 29-28 on page 343
W
A
DATA0
CLOCK is tied low by the TWI as long as RHR is full
A
describes the clock synchronization in Read mode.
DATA1
DATA0 is not read in the RHR
SCL is stretched on the last bit of DATA1
AT91SAM7L128/64 Preliminary
Rd DATA0
A
Rd DATA1
DATA1
DATA2
NA
Rd DATA2
DATA2
S
ADR
343