cs5535 National Semiconductor Corporation, cs5535 Datasheet - Page 164
![no-image](/images/no-image-200.jpg)
cs5535
Manufacturer Part Number
cs5535
Description
Geode Cs5535 Companion Multi-function South Bridge
Manufacturer
National Semiconductor Corporation
Datasheet
1.CS5535.pdf
(555 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
cs5535-KSZ
Manufacturer:
CIRRUSLOGIC
Quantity:
20 000
Part Number:
cs5535-UDC
Manufacturer:
AMD
Quantity:
20 000
Part Number:
cs5535-UDCF
Manufacturer:
AMD
Quantity:
20 000
- Current page: 164 of 555
- Download datasheet (4Mb)
www.national.com
PMC Functional Description
d) If SLP_CLK_EN# is not enabled, and if at least one of
the following PM_OUT_SLPCTL, SLEEP_X, or SLEEP_Y
registers is enabled, then Sleep wakeup is possible only
after the longest delay of the three. The delays could be
zero.
e)
PM_OUT_SLPCTL, SLEEP_X, or SLEEP_Y registers are
not enabled, then Sleep wakeup is possible immediately.
f) If SLP_CLK_EN# is enabled and the delay associated
with the PM_OUT_SLPCTL register is longer than or equal
to the delay associated with SLP_CLK_EN#, then the
PCI/IDE outputs will not be disabled.
If enabled, the de-assertion of WORKING is assumed to
remove Working power and all clock sources except 32
kHz; that is, the Standby state is entered. In this state, the
PMC, disables its interface to all circuits connected to
Working power and asserts RESET_OUT# before de-
assertion of WORKING. RESET_OUT# remains asserted
throughout Standby.
WORK_AUX is an auxiliary control for the Standby state
with no specific use. It can be de-asserted any time before
or after WORKING.
WORKING and WORK_AUX are independent controls, but
the use of either implies that Standby state is to be entered.
In both cases, the PMC disables all circuits connected to
Working power and asserts reset. However, since they are
independent, one may be left on while the other is de-
asserted.
4.17.3.4 Wakeup Events
If the system has been put to Sleep, only preprogrammed
wakeup events can get the system running again. The
PMC contains the controls that allow the system to respond
to the selected wakeup events.
On wakeup from Sleep (not Standby, but Sleep Wakeup)
(see Figure 4-53 on page 161), the PMC immediately de-
asserts SLP_CLK_EN# to turn system clocks back on. It
also re-enables PCI/IDE outputs to allow output drivers to
return to their operational levels. Next it de-asserts
SLEEP_X and SLEEP_Y based on programmable delays.
Alternate SLEEP_X and SLEEP_Y interactions are shown
as dotted lines. Lastly, the PMC, re-enables PCI/IDE inputs
after a programmable delay and de-asserts Sleep Request.
The GLCP starts any on-chip PLLs and waits for them to
become stable. Then the GLCP de-asserts SUSP# to the
processor. When the processor de-asserts SUSPA#, the
GLCP de-asserts Sleep Acknowledge. The PMC allows the
wakeup event to assert a System Control Interrupt (SCI).
After a wakeup event:
a) PCI/IDE outputs are re-enabled after SLP_CLK_EN# is
de-asserted.
If
SLP_CLK_EN#
is
not
enabled,
(Continued)
and
the
164
b) PCI/IDE inputs are re-enabled at Sleep wakeup or after
a programmable delay. Generally, PCI/IDE inputs are nor-
mally used with a delay and that delay is longer than any
de-assertion delay associated with SLEEP_X and/or
SLEEP_Y. Re-enabling PCI/IDE inputs is generally not
useful at the beginning of a wakeup sequence.
c) Sleep Request is de-asserted at Sleep wakeup or after a
programmable delay. Sleep Request is kept de-asserted
until the PCI/IDE inputs are re-enabled. Generally, the
enable and delay values in PM_SED (PMS I/O Offset 14h)
and PM_IN_SLPCTL (PMS I/O Offset 20h) should always
be the same.
d) If used, SLEEP_X/SLEEP_Y delay should be set to
occur
PM_OUT_SLPCTL
PM_IN_SLPCTL (PMS I/O Offset 20h). If the delays for
SLEEP_X/SLEEP_Y are longer than the PM_IN_SLPCTL
delay, then SLEEP_X/SLEEP_Y de-assert at the same
time as the PCI/IDE inputs are re-enabled.
On wakeup from Standby (not Sleep, but Standby Wakeup)
the PMC asserts WORKING and performs a system reset.
RESET_OUT# is de-asserted after a programmable delay
and the normal software start-up sequence begins. How-
ever, early in the sequence, the software checks the PMC
state to determine if waking from Standby (PMS I/O Offset
54h[0]). If yes, then the system state is potentially restored
from non-volatile storage.
If enabled, WORK_AUX may be asserted before or after
RESET_OUT# is de-asserted.
4.17.3.5 Fail-Safe Power Off
compliant fail-safe power off button. This logic uncondition-
ally de-asserts the WORKING and WORK_AUX signals if
the On/Off button is held down for a programmable delay.
For ACPI compliance, this delay should be set to four sec-
onds.
4.17.3.6 Wake Events Status and SCI
When enabled, a wake event from the general wake events
register (see Section 5.16.4 "GPIO Interrupt and PME Reg-
isters" on page 462) set its status bit and the "WAK_STS"
bit and causes a system control interrupt (SCI). The Sleep
button, RTC alarm, and power button when asserted,
always set their status bit. They set the "WAK_STS" bit and
generate an SCI only when their enable bit is set. When
overflowed, the PM timer sets its status bit. This overflow
condition does not cause a wakeup event but if enabled, it
generates an SCI. The event’s status is cleared by writing a
one to it.
The PMC provides the support logic to implement an ACPI
between
the
(PMS
delays
I/O
Offset
programmed
0Ch)
Revision 0.8
and
in
Related parts for cs5535
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![mma1270keg](/images/no-image3.png)
Part Number:
Description:
Freescale Semiconductor Technical Data
Manufacturer:
National Semiconductor Corporation
Datasheet:
![ADC12034](/images/no-image3.png)
Part Number:
Description:
Self-calibrating 12-bit Plus Sign Serial I/o A/d Converters With Mux And Sample/hold
Manufacturer:
National Semiconductor Corporation
Datasheet:
![LMX2350](/images/no-image3.png)
Part Number:
Description:
Pllatinum Tm Fractional N Rf / Integer N If Dual Low Power Frequency Synthesizer
Manufacturer:
National Semiconductor Corporation
Datasheet:
![LMX2324](/images/no-image3.png)
Part Number:
Description:
Pllatinum? 2.0 Ghz Frequency Synthesizer For Rf Personal Communications
Manufacturer:
National Semiconductor Corporation
Datasheet:
![LMX2301](/images/no-image3.png)
Part Number:
Description:
Pllatinumtm 160 Mhz Frequency Synthesizer For Rf Personal Communications
Manufacturer:
National Semiconductor Corporation
Datasheet:
![NDS8963](/images/no-image3.png)
Part Number:
Description:
Dual N-channel Enhancement Mode Field Effect Transistor
Manufacturer:
National Semiconductor Corporation
Datasheet:
![LM1201](/images/no-image3.png)
Part Number:
Description:
Video Amplifier System (obsolete)
Manufacturer:
National Semiconductor Corporation
Datasheet:
![LM3501TL-16](/images/no-image3.png)
Part Number:
Description:
Synchronous Step-up DC/DC Converter For White Led Applications
Manufacturer:
National Semiconductor Corporation
Datasheet:
![AD9621](/images/no-image3.png)
Part Number:
Description:
CLC420 - High Speed, Voltage Feedback op Amp, Package: Lcc, Pin Nb=20
Manufacturer:
National Semiconductor Corporation
Datasheet:
![LM2403](/images/no-image3.png)
Part Number:
Description:
Monolithic Triple 4.5 CRT Driver
Manufacturer:
National Semiconductor Corporation
Datasheet:
![LM592M](/images/no-image3.png)
Part Number:
Description:
Differential Video Amplifier
Manufacturer:
National Semiconductor Corporation
Datasheet:
![ADC10061](/images/no-image3.png)
Part Number:
Description:
ADC10061 - 10-Bit 600 NS A/D Converter With Input Multiplexer And Sample/Hold, Package: Soic Wide, Pin Nb=20
Manufacturer:
National Semiconductor Corporation
Datasheet:
![DS36277TMX](/images/no-image3.png)
Part Number:
Description:
DS36277 - Dominant Mode Multipoint Transceiver, Package: Soic Narrow, Pin Nb=8
Manufacturer:
National Semiconductor Corporation
Datasheet:
![DS3654](/images/no-image3.png)
Part Number:
Description:
Printer Solenoid Driver
Manufacturer:
National Semiconductor Corporation
Datasheet:
![DS3662](/images/no-image3.png)
Part Number:
Description:
Quad High Speed Trapezoidal Bus Transceiver
Manufacturer:
National Semiconductor Corporation
Datasheet: