lpc4310 NXP Semiconductors, lpc4310 Datasheet - Page 36

• Manufacturer Part Number: lpc4310
• Description: Lpc4350/30/20/10 32-bit Arm Cortex-m4/m0 Mcu; Up To 264 Kb Sram; Ethernet; Two High-speed Usbs; Advanced Configurable Peripherals
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC4350_30_20_10
Objective data sheet
7.12.1.1 Features
7.11.2.1 Features
7.12.1 General Purpose DMA (GPDMA)
7.12 AHB peripherals
The DMA controller allows peripheral-to memory, memory-to-peripheral,
peripheral-to-peripheral, and memory-to-memory transactions. Each DMA stream
provides unidirectional serial DMA transfers for a single source and destination. For
example, a bidirectional port requires one stream for transmit and one for receives. The
source and destination areas can each be either a memory region or a peripheral for
master 1, but only memory for master 0.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Each SGPIO input/output slice can be used to perform a serial to parallel or parallel to
serial data conversion.
16 SGPIO input/output slices each with a 32-bit FIFO that can shift the input value
from a pin or an output value to a pin with every cycle of a shift clock.
Each slice is double-buffered.
Interrupt is generated on a full FIFO, shift clock, or pattern match.
Slices can be concatenated to increase buffer size.
Each slice has a 32-bit pattern match filter.
Eight DMA channels. Each channel can support an unidirectional transfer.
16 DMA request lines.
Single DMA and burst DMA request signals. Each peripheral connected to the DMA
Controller can assert either a burst DMA request or a single DMA request. The DMA
burst size is set by programming the DMA Controller.
Memory-to-memory, memory-to-peripheral, peripheral-to-memory, and
peripheral-to-peripheral transfers are supported.
Scatter or gather DMA is supported through the use of linked lists. This means that
the source and destination areas do not have to occupy contiguous areas of memory.
Hardware DMA channel priority.
AHB slave DMA programming interface. The DMA Controller is programmed by
writing to the DMA control registers over the AHB slave interface.
Two AHB bus masters for transferring data. These interfaces transfer data when a
DMA request goes active. Master 1 can access memories and peripherals, master 0
can access memories only.
32-bit AHB master bus width.
Incrementing or non-incrementing addressing for source and destination.
Programmable DMA burst size. The DMA burst size can be programmed to more
efficiently transfer data.
Internal four-word FIFO per channel.
Supports 8, 16, and 32-bit wide transactions.
Big-endian and little-endian support. The DMA Controller defaults to little-endian
mode on reset.
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 29 October 2010
32-bit ARM Cortex-M4/M0 microcontroller
LPC4350/30/20/10
© NXP B.V. 2010. All rights reserved.
36 of 85