c8051t602 Silicon Laboratories, c8051t602 Datasheet - Page 62

• Manufacturer Part Number: c8051t602
• Description: Mixed Signal Otp Eprom Mcu Family
• Manufacturer: Silicon Laboratories

C8051T600/1/2/3/4/5
9.2.2. Data Memory
The CIP-51 includes 256 bytes of internal RAM mapped into the data memory space from 0x00 through
0xFF. The lower 128 bytes of data memory are used for general purpose registers and scratch pad mem-
ory. Either direct or indirect addressing may be used to access the lower 128 bytes of data memory. Loca-
tions 0x00 through 0x1F are addressable as four banks of general purpose registers, each bank consisting
of eight byte-wide registers. The next 16 bytes, locations 0x20 through 0x2F, may either be addressed as
bytes or as 128 bit locations accessible with the direct addressing mode.
The upper 128 bytes of data memory are accessible only by indirect addressing. This region occupies the
same address space as the Special Function Registers (SFR) but is physically separate from the SFR
space. The addressing mode used by an instruction when accessing locations above 0x7F determines
whether the CPU accesses the upper 128 bytes of data memory space or the SFRs. Instructions that use
direct addressing will access the SFR space. Instructions using indirect addressing above 0x7F access the
upper 128 bytes of data memory. Figure 9.3 illustrates the data memory organization of the CIP-51.
9.2.3. General Purpose Registers
The lower 32 bytes of data memory, locations 0x00 through 0x1F, may be addressed as four banks of gen-
eral-purpose registers. Each bank consists of eight byte-wide registers designated R0 through R7. Only
one of these banks may be enabled at a time. Two bits in the program status word, RS0 (PSW.3) and RS1
(PSW.4), select the active register bank (see description of the PSW in Figure 9.4). This allows fast context
switching when entering subroutines and interrupt service routines. Indirect addressing modes use regis-
ters R0 and R1 as index registers.
62
0xFF
0x7F
0x2F
0x1F
0x80
0x30
0x20
0x00
(Indirect Addressing
(Direct and Indirect
Figure 9.3. Data Memory Map
General Purpose
INTERNAL DATA ADDRESS SPACE
Upper 128 RAM
Bit Addressable
Addressing)
Registers
Only)
Rev. 0.5
(Direct Addressing Only)
Special Function
Lower 128 RAM
(Direct and Indirect
Addressing)
Register's