mc9s08qd4 Freescale Semiconductor, Inc, mc9s08qd4 Datasheet - Page 161

• Manufacturer Part Number: mc9s08qd4
• Description: Hcs08 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

Chapter 12
Development Support
12.1
Development support systems in the HCS08 include the background debug controller (BDC). The BDC
provides a single-wire debug interface to the target MCU that provides a convenient interface for
programming the on-chip flash and other nonvolatile memories. The BDC is also the primary debug
interface for development and allows non-intrusive access to memory data and traditional debug features
such as CPU register modify, breakpoints, and single instruction trace commands.
In the HCS08 Family, address and data bus signals are not available on external pins (not even in test
modes). Debug is done through commands fed into the target MCU via the single-wire background debug
interface. The debug module provides a means to selectively trigger and capture bus information so an
external development system can reconstruct what happened inside the MCU on a cycle-by-cycle basis
without having external access to the address and data signals.
12.1.1
The method for forcing active background mode depends on the specific HCS08 derivative. For the
MC9S08QD4 series, you can force active background mode by holding the BKGD pin low as the MCU
exits the reset condition independent of what caused the reset. If no debug pod is connected to the BKGD
pin, the MCU will always reset into normal operating mode.
12.1.2
The alternative BDC clock source for MC9S08QD4 series is the ICGCLK. See
Source
Freescale Semiconductor
(S08ICSV1),” for more information about ICGCLK and how to select clock sources.
Introduction
Forcing Active Background
Module Configuration
MC9S08QD4 Series MCU Data Sheet, Rev. 3
Chapter 9, “Internal Clock
161