mc9s08qd4 Freescale Semiconductor, Inc, mc9s08qd4 Datasheet - Page 69

• Manufacturer Part Number: mc9s08qd4
• Description: Hcs08 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

Chapter 6
Parallel Input/Output Control
This section explains software controls related to parallel input/output (I/O) and pin control. The
MC9S08QD4 series has one parallel I/O port which include a total of 4 I/O pins, one output-only pin, and
one input-only pin. See
assignments and external hardware considerations of these pins.
All of these I/O pins are shared with on-chip peripheral functions as shown in
modules have priority over the I/Os so that when a peripheral is enabled, the I/O functions associated with
the shared pins are disabled. After reset, the shared peripheral functions are disabled so that the pins are
controlled by the I/O. All of the I/Os are configured as inputs (PTxDDn = 0) with pullup devices disabled
(PTxPEn = 0), except for output-only pin PTA4 which defaults to BKGD/MS pin.
6.1
Reading and writing of parallel I/Os is performed through the port data registers. The direction, either input
or output, is controlled through the port data direction registers. The parallel I/O port function for an
individual pin is illustrated in the block diagram shown in
Freescale Semiconductor
Port Data and Data Direction
Not all general-purpose I/O pins are available on all packages. To avoid
extra current drain from floating input pins, the user’s reset initialization
routine in the application program must either enable on-chip pullup devices
or change the direction of unconnected pins to outputs so the pins do not
float.
Section Chapter 2, “External Signal
MC9S08QD4 Series MCU Data Sheet, Rev. 3
NOTE
Figure
Description,” for more information about pin
6-1.
Table
2-1. The peripheral
69