HD6412332 RENESAS [Renesas Technology Corp], HD6412332 Datasheet - Page 322

• Manufacturer Part Number: HD6412332
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2300 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Activation by Falling Edge on DREQ Pin: DREQ pin falling edge detection is performed in
synchronization with DMAC internal operations. The operation is as follows:
[1] Activation request wait state: Waits for detection of a low level on the DREQ pin, and
[2] Transfer wait state: Waits for DMAC data transfer to become possible, and switches to [3].
[3] Activation request disabled state: Waits for detection of a high level on the DREQ pin, and
After DMAC transfer is enabled, a transition is made to [1]. Thus, initial activation after transfer is
enabled is performed on detection of a low level.
Activation Source Acceptance: At the start of activation source acceptance, a low level is
detected in both DREQ pin falling edge sensing and low level sensing. Similarly, in the case of an
internal interrupt, the interrupt request is detected. Therefore, a request is accepted from an
internal interrupt or DREQ pin low level that occurs before execution of the DMABCRL write to
enable transfer.
When the DMAC is activated, take any necessary steps to prevent an internal interrupt or DREQ
pin low level remaining from the end of the previous transfer, etc.
Rev.4.00 Sep. 07, 2007 Page 292 of 1210
REJ09B0245-0400
switches to [2].
switches to [1].
Internal write signal
Internal read signal
External address
Figure 7.42 Example in Which Low Level is Not Output at TEND Pin
Internal address
HWR, LWR
TEND
φ
External write by CPU, etc.
DMA
read
Not output
DMA
write