S912XET512J3VALR Freescale Semiconductor, S912XET512J3VALR Datasheet - Page 350

• Manufacturer Part Number: S912XET512J3VALR
• Description: 16-bit Microcontrollers - MCU 16 BIT,512K FLASH
• Manufacturer: Freescale Semiconductor

Specifications of S912XET512J3VALR

• Rohs: yes
• Core: HCS12X
• Processor Series: MC9S12XE
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 32 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-112
• Mounting Style: SMD/SMT

Chapter 9 Security (S12XE9SECV2)
9.1.4.2
Special single chip mode means BDM is active after reset. The availability of BDM firmware commands
depends on the security state of the device. The BDM secure firmware first performs a blank check of both
the Flash memory and the EEPROM. If the blank check succeeds, security will be temporarily turned off
and the state of the security bits in the appropriate Flash memory location can be changed If the blank
check fails, security will remain active, only the BDM hardware commands will be enabled, and the
accessible memory space is restricted to the peripheral register area. This will allow the BDM to be used
to erase the EEPROM and Flash memory without giving access to their contents. After erasing both Flash
memory and EEPROM, another reset into special single chip mode will cause the blank check to succeed
and the options/security byte can be programmed to “unsecured” state via BDM.
While the BDM is executing the blank check, the BDM interface is completely blocked, which means that
all BDM commands are temporarily blocked.
9.1.4.3
9.1.5
Unsecuring the microcontroller can be done by three different methods:
9.1.5.1
In normal modes (single chip and expanded), security can be temporarily disabled using the backdoor key
access method. This method requires that:
350
•
•
•
•
•
•
•
•
•
•
1. Backdoor key access
2. Reprogramming the security bits
3. Complete memory erase (special modes)
•
BDM firmware commands are disabled.
BDM hardware commands are restricted to the register space.
Execution of Flash and EEPROM commands is restricted. Please refer to the NVM block guide for
details.
Tracing code execution using the DBG module is disabled.
Debugging XGATE code (breakpoints, single-stepping) is disabled.
BDM operation is completely disabled.
Internal Flash memory and EEPROM are disabled.
Execution of Flash and EEPROM commands is restricted. Please refer to the FTM block guide for
details.
Tracing code execution using the DBG module is disabled.
Debugging XGATE code (breakpoints, single-stepping) is disabled
The backdoor key at 0xFF00–0xFF07 (= global addresses 0x7F_FF00–0x7F_FF07) has been
programmed to a valid value.
Unsecuring the Microcontroller
Special Single Chip Mode (SS)
Expanded Modes (NX, ES, EX, and ST)
Unsecuring the MCU Using the Backdoor Key Access
MC9S12XE-Family Reference Manual Rev. 1.25
Freescale Semiconductor