MA240029 Microchip Technology, MA240029 Datasheet - Page 78

• Manufacturer Part Number: MA240029
• Description: Daughter Cards & OEM Boards PIC24FJ128GA310 Gen Purpose PIM
• Manufacturer: Microchip Technology

Specifications of MA240029

• Rohs: yes
• Product: Daughter Cards
• Core: PIC
• Description/function: Plug-in module
• Interface Type: I2C, SPI
• Tool Is For Evaluation Of: PIC24FJ128GA310
• For Use With: Explorer 16 Development Board

PIC24FJ128GA310 FAMILY
5.1.6
Each DMA channel functions independently of the oth-
ers, but also competes with the others for access to the
data and DMA busses. When access collisions occur,
the DMA Controller arbitrates between the channels
using a user-selectable priority scheme. Two schemes
are available:
• Round-Robin: When two or more channels col-
• Fixed: When two or more channels collide, the
5.2
To set up a DMA channel for a basic data transfer:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Enable the trigger source interrupt.
DS39996F-page 78
lide, the lower-numbered channel receives priority
on the first collision. On subsequent collisions, the
higher numbered channels each receive priority,
based on their channel number.
lowest numbered channel always receives
priority, regardless of past history.
Enable the DMA Controller (DMAEN = 1) and
select an appropriate channel priority scheme
by setting or clearing PRSSEL.
Program DMAH and DMAL with appropriate
upper and lower address boundaries for data
RAM operations.
Select the DMA channel to be used and disable
its operation (CHEN = 0).
Program the appropriate Source and Destination
addresses for the transaction into the channel’s
DMASRCn and DMADSTn registers. For PIA
mode addressing, use the base address value.
Program the DMACNTn register for the number
of triggers per transfer (One-Shot or Continuous
modes), or the number of words (bytes) to be
transferred (Repeated modes).
Set or clear the SIZE bit to select the data size.
Program the TRMODE bits to select the Data
Transfer mode.
Program the SAMODE and DAMODE bits to
select the addressing mode.
Enable the DMA channel by setting CHEN.
Typical Setup
CHANNEL PRIORITY
5.3
Unlike other peripheral modules, the channels of the
DMA Controller cannot be individually powered down
using the Peripheral Module Disable (PMD) registers.
Instead, the channels are controlled as two groups.
The DMA0MD bit (PMD7<4>) selectively controls
DMACH0 through DMACH3. The DMA1MD bit
(PMD7<5>) controls DMACH4 and DMACH5. Setting
both bits effectively disables the DMA Controller.
5.4
The DMA Controller uses a number of registers to con-
trol its operation. The number of registers depends on
the number of channels implemented for a particular
device.
There are always four module level registers (one
control and three buffer/address):
• DMACON: DMA Control Register
• DMAH and DMAL: High and Low Address Limit
• DMABUF: DMA Data Buffer
Each of the DMA channels implements five registers
(two control and three buffer/address):
• DMACHn: DMA Channel Control Register
• DMAINTn: DMA Channel Interrupt Control Register
• DMASRCn: Data Source Address Pointer for
• DMADSTn: Data Destination Source for Channel n
• DMACNTn: Transaction Counter for Channel n
For PIC24FJ128GA310 family devices, there are a
total of 34 registers.
Registers
(Register
(Register
Channel n
Peripheral Module Disable
Registers
5-2)
5-3)
 2010-2011 Microchip Technology Inc.
(Register
5-1)