UPD78F0513AGA-GAM-AX Renesas Electronics America, UPD78F0513AGA-GAM-AX Datasheet - Page 731

• Manufacturer Part Number: UPD78F0513AGA-GAM-AX
• Description: MCU 8BIT 48-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx2r

Specifications of UPD78F0513AGA-GAM-AX

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 41
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

78K0/Kx2
27.6.6 Other signal pins
to EXCLK/X2/P122.
27.6.7 Power supply
programmer, and the V
monitor function with the flash memory programmer, even when using the on-board supply voltage.
R01UH0008EJ0401 Rev.4.01
Jul 15, 2010
Connect X1 and X2 in the same status as in the normal operation mode when using the on-board clock.
To input the operating clock from the dedicated flash memory programmer, however, connect CLK of the programmer
Cautions 1. Only the internal high-speed oscillation clock (f
Note With products without an EV
To use the supply voltage output of the flash memory programmer, connect the V
To use the on-board supply voltage, connect in compliance with the normal operation mode.
However, be sure to connect the V
Supply the same other power supplies (EV
2. Only the X1 clock (f
3. For the product with an on-chip debug function (
P31/INTP2/OCD1A and P121/X1/OCD0A as follows when writing the flash memory with a flash
memory programmer.
• P31/INTP2/OCD1A: Connect to EV
• P121/X1/OCD0A:
SS
pin to GND of the flash memory programmer.
DD
SS
X
) or external main system clock (f
Connect to V
pin, connect them to V
and V
DD
SS
, EV
pins to V
SS
, AV
SS
SS
Note
Note
REF
DD
via a resistor.
, and AV
via a resistor.
and GND of the flash memory programmer to use the power
SS
.
RH
SS
) can be used when CSI10 is used.
) as those in the normal operation mode.
EXCLK
μ
PD78F05xxD and 78F05xxDA), connect
) can be used when UART6 is used.
CHAPTER 27 FLASH MEMORY
DD
pin to V
DD
of the flash memory
731